How can I get the fault code on my Mazda MX5?
You can do this yourself without the need for any special scanners, or a costly visit to your local Mazda dealer, all you need is a LED and resistor, but you only need that for engine codes, other faults are indicated via the corresponding dashboard indicators.
How to get code 111 on Mazda 626 probe?
So for Mazda 626 owners you can completely skip Step 6, for other vehicles owners (not Mazda 626, MX6, Probe, or Telstar) with EEC-IV that stumble upon this article in the future, step 6 might apply to you. 7. After a pause of about 4 to 15 seconds if everything checks out OK, you should receive a code “111.”
Where are the Check Engine light codes on a Mazda 626?
These are the main check engine light codes for MECS-II 626’s. You put the car into diagnostic mode by using a jumper wire between the C (TEN) & E (GROUND) pins of the diagnostic box under the hood of your car.
Where is the OBDII connector on a 2002 Mazda MX5?
Cars built after 2002 (and sometimes earlier in other parts of the world) are fitted with an OBDII Connector located at the top of the cabin fuse box, underneath the steering wheel. An OBDII Scan Tool is required to read and clear error codes on these cars.
How to check ABS code on Mazda MX5?
1. To check DTC (Diagnostic Trouble Codes) on the Mazda MX5 ABS system; turn ignition switch to the off position and bridge the TBS and GND terminals in the DIAGNOSTIC socket under the bonnet (see the Diagnostic Connector photo below), using a jumper wire or paperclip. 2.
Where are the OBD codes on a pre 1995 Mazda?
Step by step guide on how to retrieve and decode Mazda pre 1995 OBD system trouble codes. Step 1 – Start the engine and allow to warm up to operating temperature, then turn the engine “OFF”. Step 2 – Next, install a jumper wire from the TEN terminal to the GND terminal, located either under the dash or hood depending on model.
How can I tell if my Mazda has an error code?
Mazda used MECS-II and Ford’s EEC-IV system. Error codes are deciphered through a series of blinking check engine light (CEL) also known as a malfunction indicator lamp (MIL). It is comparable to morse code coming from the check engine light while the car is in diagnostic mode.
So for Mazda 626 owners you can completely skip Step 6, for other vehicles owners (not Mazda 626, MX6, Probe, or Telstar) with EEC-IV that stumble upon this article in the future, step 6 might apply to you. 7. After a pause of about 4 to 15 seconds if everything checks out OK, you should receive a code “111.”