What does the at warning light on a Mazda 2 mean?
Warning Light Meaning: The Mazda 2 AT warning light illuminates in orange when a fault has been detected with the Automatic Transaxle, or Automatic Transmission. This includes the transmission, axle, and differential. The illumination of the AT warning light indicates an electrical fault with the system.
What to do if your Mazda light turns off?
There is no problem if the light turns off after a while. Contact an expert repairer, we recommend an Authorised Mazda Repairer if the light illuminates/flashes continuously.
When does the amber light come on on a Mazda 2?
The mazda 2 amber i-stop warning light illuminates when: • The ignition is switched on, but should go out shortly after engine startup. • The bonnet is opened when the system is in engine stop mode. • Driver seat belt undone and door is opened. In these instances, start the vehicle normally.
When do the warning lights flash on a Mazda CX 5?
The light flashes when the engine coolant temperature is extremely high, and illuminates when the engine coolant temperature increases further. Drive slowly to reduce engine load until you can find a safe place to stop the vehicle and wait for the engine to cool down. This indicates the possibility of overheating.
What does a red light look like on a Mazda 6?
Mazda 6 I have a red light that looks like car flashing on… I have a red light… I have a red light that looks like car flashing on the instrument panel when I shut the car off and get out of it. It is killing the battery every 24 hours if I don’t drive the car. Everything is turned off in the car and the key is out and the doors are locked.
Why is the security light blinking on my Mazda 3?
The flashing light indicates the immobilizer system is active and is normal behavior. For some reason, for the past three months, I hadn’t noticed the blinking light. In my last few cars, there was an alarm light either on top of the dash or on the ends of the door lock buttons that flashed when the alarm was activated.
What does master warning light on Mazda mean?
The master warning light displays when a warning message occurs. This indicates a malfunction with the vehicle system. Check the message indicated in the display and consult an expert repairer, we recommend an Authorised Mazda Repairer.
What does the symbol mean on the Mazda 3 dashboard?
If the light remains on when the parking brake has been released, it indicates a malfunction. If the light flashes with the parking brake applied, it indicates a malfunction. 2. This symbol indicates a malfunction. Have vehicle checked if any of those faults occur.
What is the service light on a Mazda?
Most Mazda vehicles are equipped with an electronic computer system, linked to the dashboard, that tells drivers when maintenance is required. If the driver neglects a service light, such as the “CHANGE ENGINE OIL” light, he or she runs the risk of damaging the engine – or worse, ending up stranded on the side of the road or causing an accident.
What should I do if my Mazda 3 Dashboard Light comes on?
Immediate action is required if this light comes on else engine components may be damaged. Other symptoms include a loss of power, knocking or pinging noise. Immediately and as soon as safely possible, pull over and switch off the engine. Allow 15 minutes or so for engine to cool down. Check for water leaks. If no leaks, continue driving.
What should I do if my Mazda CX 5 has a warning light?
4. Start the engine and check the warning light. If the light remains illuminated even after you add oil, stop the engine immediately and have your vehicle towed to an Authorized Mazda Dealer. Do not run the engine if the oil pressure is low. It could result in extensive engine damage.
What does the Check Engine light on a Mazda 3 mean?
When the check engine light comes on, a fault code is stored in the ECU. Diagnostic equipment is required to read the fault codes. Description: The Mazda 3 i-stop is an engine start/stop system that turns off the engine when the vehicle becomes stationary to save fuel.
Where do I find the warning light on my Mazda?
The warning contents can be verified on the centre display. If the warning light is turned on, select icon on the home screen to display the application screen. Select “Vehicle Status Monitor”.
When does the I stop light go out on a Mazda 2?
‘i-stop’ is Mazda’s version of start / stop technology to help improve fuel economy and reduced exhaust gas emissions. The mazda 2 amber i-stop warning light illuminates when: • The ignition is switched on, but should go out shortly after engine startup. • The bonnet is opened when the system is in engine stop mode.
How can I change the Mazda active driving display?
And More! The Active Driving Display can be altered from the Settings page of the MAZDA CONNECT ™ system. Drivers can change projection height, brightness, angle, and information they wish to have displayed. Drivers can also turn the Active Driving Display off if they find it to be a distraction.