Can you install a used airbag module?
Getting a used airbag module is cheaper than getting a new one but the module will still need to be re-programmed. This is because when you install a different module inside your vehicle, used or unused, you will need to program it to your VIN, which requires a dealer to happen.
Where is the airbag module located on a Mazda?
Follow these instructions to learn how to remove the airbag module on Mazda vehicles model years: 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017. In most Mazda vehicles, the airbag module is located under the center console. Disconnect the negative battery terminal. Remove the center console trim. It can be lifted up.
What’s the best way to replace a Mazda airbag?
A cheaper alternative is to remove the airbag module from the vehicle and send it to a specialist to reset the module to original settings. You can find third party vendors that will reset your Mazda airbag module (eBay link) on sites like eBay.
How does the airbag control module work in a car?
During a collision the airbag control module receives information from the impact sensor, which then, relays a signal to deploy the airbags. The airbag sensor is then locked until it is either replaced or reprogrammed. Each vehicle can have many types of modules depending on which SRS features were equipped with the car.
Where are the air bags located in a car?
They are mounted in different locations throughout the vehicle. Some common places are under the driver and passenger seat, center console, kick panel, under radios and behind the steering column. The airbag control module is good until a deployment occurs.
How to remove and replace the airbag module on Mazda 3?
All you will need to do is remove the cup holder and right underneath it and next to the emergency brake is the SRS Airbag Module. 2010 Mazda 3 Airbag Module Removal Replacement and Location. Mazda 3 Air Bag Module 2011 Mazda 3 Airbag Module Removal Replacement and Location. Mazda 3 Air Bag Module
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
What happens when air bag deploys in Mazda?
Unless all safety procedures are followed, injury could result. Have an expert repairer, we recommend an Authorised Mazda Repairer safely dispose of the air bag system or scrap an air bag equipped vehicle. When an air bag deploys, a loud inflation noise can be heard and some smoke will be released.