How to remove the drive belt on a Mazda CX-5?
Install the splash shield.. 1. Remove the generator drive belt.. 2. Apply a clean cloth to the water pump drive belt as shown in the figure. 3. Pull the cloth in the direction of the arrow and rotate the crankshaft pulley clockwise.
How often do you replace the serpentine belt on a Mazda?
Reinstall the access panel cover. Reinstall the wheel and lower the vehicle. Mazda recommends that the serpentine belt is replaced every 35,000 miles. The serpentine belt may also be referred to as the drive belt, accessory belt, or the alternator/air conditioner belt.
How to remove generator drive belt in Mazda 3?
2. Insert a wrench onto the cast hexagon on the drive belt auto tensioner and release the tension by slowly turning in the direction shown in the figure. 3. Remove the generator drive belt. 4. Install the generator drive belt. 5. Rotate the crankshaft pulley clockwise approx. halfway and verify that the generator drive belt is installed correctly.
What kind of belt does a Mazda 3 use?
In this guide, you will find instructions on how to change the serpentine belt (engine drive belt) on Mazda’s four-cylinder engine. The 2.5L is one of the most popular engines Mazda made, and it is found on several models, including Mazda 3, 5, 6, and even Tribute.
Install the splash shield.. 1. Remove the generator drive belt.. 2. Apply a clean cloth to the water pump drive belt as shown in the figure. 3. Pull the cloth in the direction of the arrow and rotate the crankshaft pulley clockwise.
2. Insert a wrench onto the cast hexagon on the drive belt auto tensioner and release the tension by slowly turning in the direction shown in the figure. 3. Remove the generator drive belt. 4. Install the generator drive belt. 5. Rotate the crankshaft pulley clockwise approx. halfway and verify that the generator drive belt is installed correctly.
How to remove the water pump drive belt?
Remove the water pump drive belt. 1. Set one side of the water pump drive belt into the groove of the crankshaft pulley. 2. Set the other side of the water pump drive belt into the groove of the water pump pulley with the smaller circumference.