What are the LATCH Lower Anchors on a Mazda 3?
Your Mazda is equipped with LATCH lower anchors for attachment of specially designed LATCH child-restraint systems in the rear seats. Both anchors must be used, otherwise the seat will bounce around and put the child in danger. Most LATCH child-restraint systems must also be used in conjunction with a tether to be effective.
How to remove the front seat in a Mazda 3?
Detach hook A and B while pulling the adjuster cover No.1 in the direction of the arrow (1), (2) and remove it in the direction of arrow (3) shown in the figure. 7.
How to secure child restraint in Mazda 3?
Secure the child-restraint system using BOTH LATCH lower anchors, following the child-restraint system manufacturer’s instruction. Pull on the child-restraint to be sure both anchors are engaged. If your child-restraint system came equipped with a tether, that means it is very important to properly secure the tether for child safety.
How do you replace the front passenger seat?
When the passenger’s seat is replaced with a new one, perform the seat weight sensor calibration using the M-MDS.. When removing the front seat out of the vehicle or putting it back in, it can be performed smoothly by removing the headrest. 1. Switch the ignition to off. 2. Remove the battery cover..
Your Mazda is equipped with LATCH lower anchors for attachment of specially designed LATCH child-restraint systems in the rear seats. Both anchors must be used, otherwise the seat will bounce around and put the child in danger. Most LATCH child-restraint systems must also be used in conjunction with a tether to be effective.
Detach hook A and B while pulling the adjuster cover No.1 in the direction of the arrow (1), (2) and remove it in the direction of arrow (3) shown in the figure. 7.
Where is the anchor point on a seat belt?
When the existing anchor point is located in the side of the drive shaft tunnel: Using the 7/16″ fine thread hex bolt (Grade 5 or better) from the restraint that you’re replacing or a new hex bolt from Wesco, simply insert the hex bolt through the hole in the (D) End of the bucket seatbelt end as shown in Fig. 4 .
Secure the child-restraint system using BOTH LATCH lower anchors, following the child-restraint system manufacturer’s instruction. Pull on the child-restraint to be sure both anchors are engaged. If your child-restraint system came equipped with a tether, that means it is very important to properly secure the tether for child safety.