How do you replace Shock on Mazda Miata?
Loosen the wheel nuts, then lift the car and support it on jack stands; see either the Maintenance section from Tips from the Garage Web page, the Mazda Shop Manual, or the Enthusiast’s Manual for further details.
What kind of suspension does a Mazda Miata have?
Getting your Mazda Miata suspension dialed in can equate to you out-handling your competition, and depending on your type of racing, will even give you better times. If your vehicle came from the factory with softer suspension, it will almost always handle poorly until the suspension is replaced with a performance setup such as coilovers.
How to check alignment on a Mazda MX-5 Miata?
Alignment 4 Wheel Alignment on a Mazda MX-5 Miata by Andrew Willliams Can you measure and check 4 wheel alignment on a “5” using string, straight edge, plumb bob, spirit level and extending rule etc. Those nay sayers should note that motorbike frame re-aligners use a jig, and tape measure ;-).
Do you need to mod a Mazda Miata?
Many people buy cars and never consider modifying them. You don’t need to mod a car to be a true car enthusiast but most cars do have something or other that can be improved. For Miata fans, we’re focusing this article on the Mazda MX-5 Miata NC 2006-2015.
Loosen the wheel nuts, then lift the car and support it on jack stands; see either the Maintenance section from Tips from the Garage Web page, the Mazda Shop Manual, or the Enthusiast’s Manual for further details.
Can a spring be replaced on a Miata?
Shock/spring replacement can be a difficult and tedious task, particularly if the Madza-recommended (i.e., shop manual) method is used. However, a number of posts to the Miata.net have indicated that this operation can be performed without changing the alignment or breaking ball joints.
How do you remove a shock absorber from a car?
Loosen the shock absorber upper shaft nut a few turns (it’s more difficult to do this after the unit is out of the car) with a 17 mm wrench and extension, but DO NOT completely remove the bolt, or the spring will separate from the shock (which is dangerous, and probably impossible to rectify once it occurs). 3.
Where is the sway bar on a Miata?
Disconnect the sway bar’s attachment to the lower A-arm linkage (14 mm socket), to allow the A-arm to swing out of the way in subsequent steps. The sway bar can be removed either where it joins the A-arm, or at the point between the main (horizontal) sway bar and the curved link that fastens to the arm.
What do you use to replace Shock mount?
Lubricate the lower shock mounting bolt with molybdenum or similar grease, and replace the bolt. Push down on the shaft of the shock, and replace the top shock mount.
How do you replace a shock absorber spring?
Make sure the unit is aligned correctly, with the spring seated properly against the shock absorber and the top mounting plate, then reinstall in the car. Use the OEM paint marks or your marking tape, etc. to replace the spring in the same orientation that is occupied prior to removal. 10.