How many miles do you have to drive to pass inspection?
How many miles to drive after resetting check engine light for inspection. On average, you would need to drive for about 50 to 100 miles to clear a check engine light. That said, it is important to note that the OBD-I and OBD-II models have slightly different operations.
How many miles for car computer to reset?
The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take up to 100 miles for all of the computer monitors to completely reset.
How many miles do you have to drive after unplugging battery?
When a car’s battery dies or is disconnected, the computer resets, erasing the internal emission monitors required to pass a smog test. You’ll be good to go once you drive 100 to 200 miles with the new battery.
Where was the 2005 Mazda Miata last serviced?
Mileage: 113,638 miles Body Type: Convertible Color: White Engine: 4 Cyl 2.0 L Accident reported. Purchased on 03/23/06 and owned in AZ until 06/01/21. Driven an estimated 6,405 miles/year. Last serviced at 89,234 miles in Gilbert, AZ on 06/14/19 • Vehicle serviced • A/C system checked.
How often do you change the air filter on a Miata?
4 wheel alignment every 15,000 miles. Stock air filter every 15,000 miles. Wiper inserts/blades every 15,000 miles. I change my spark plugs every 15,000 miles. (Stock plugs are good for about 20,000 miles.) Let’s look at the 30,000 mile maintenance. Include tune up, fuel filter, brake/clutch fluid flush and coolant flush.
What should I do at 60, 000 miles on my Miata?
This brings us to the 60,000 mile maintenance. The “Big One”. Assuming all maintenance has been done on the car to date, this is what to expect. A full tune-up and fluid change, including the brake and clutch fluid. Suspension and brakes should be checked.
Where can I find answers to my Miata questions?
The best place to find these answers is through your local Miata chapter. You have a whole network of people at your disposal, and most will be willing to tell you about their favorite repair shop, also the places to steer clear from.
When did I buy a 2002 Toyota Highlander?
Read what other owners think about the Used 2002 Toyota Highlander. Bought this car new in ’02 and have put over 260,000 miles on it and don’t regret the purchase ever and would consider buying another ’02 Highlander to replace it (with fewer miles, of course, maybe 150,000 if I could afford it). Has never let us down.
What’s the emissions readiness procedure for a 2002 Toyota?
(2002 MY vehicles will run monitor at temperatures below 14E F by cycling key to OFF and repeating drive trace). Note the IAT data for use in step 3. Drive the vehicle at a steady speed between 40-55 mph (64-88 km/h) or more for 7 minutes if IAT was below 50E F (10E C) at start-up, or 3 minutes if IAT was above 50E F (10E F) at start-up.
What kind of engine does a Toyota Highlander have?
There are two engine choices: a standard 2.4-liter four-cylinder or a 3.0-liter V6. The four-cylinder makes 155 horsepower and 163 pound-feet of torque, while the smooth V6 puts out 220 ponies and 222 lb-ft of twist. A four-speed automatic transmission is the only one offered, and it provides a “snow mode” for easy starts on slippery surfaces.
How long does it take to get Toyota emissions ready?
Drive the vehicle at a steady speed between 40-55 mph (64-88 km/h) or more for 7 minutes if IAT was below 50E F (10E C) at start-up, or 3 minutes if IAT was above 50E F (10E F) at start-up. Drive the vehicle allowing speed to fluctuate between 35-45 mph (56-72 km/h) for 16 minutes.