Are Mazdas 6 good on gas?
Sporty and stylish, the Mazda6 is an enjoyable car to drive, although it’s a bit on the snug side compared with its peers. The standard 2.5-liter four-cylinder is responsive and delivered 28 mpg overall in our tests. The uplevel turbocharged engine makes the 6 quieter and much quicker.
How many gallons does a Mazda Tribute hold?
The Mazda Tribute has a gas tank size ranging from 15.0 gallons to 17.5 gallons depending on the trim and model year.
Are there any problems with the Mazda Tribute V6?
Causing rich or lean engine conditions, flat spot, hesitation and may log codes P0171, P0172, P0173, P0174 and P0175 (fuel trim limits reached), also cold start issues can occur. Problem: Air mass meter problems are very difficult to prove, so check the following: Check for poor electrical connections at air mass meter.
What should idle speed be on Mazda Tribute?
Idle speed 600-700RPM and should rise to 650-750 with engine loads. Check operation with scanner or oscilloscope. Remedy: Replace the IAC valve as required. Causing rich or lean engine conditions, flat spot, hesitation and may log codes P0171, P0172, P0173, P0174 and P0175 (fuel trim limits reached), also cold start issues can occur.
What causes lean air / fuel mixture in Mazda Tribute?
The EGR valve leaks causing exhaust gases to enter the combustion chamber at all times, therefore creating a lean air/fuel mixture. This symptom is most noticeable at idle. To test for a leaking EGR valve temporarily block off valve with blanking gasket and recheck for lean air/fuel symptoms.
What to do if your Mazda Tribute has no output signal?
Crankshaft or camshaft sensor has no output signal. This signal is best checked with an oscilloscope. Check wiring harness for damage particularly at the front of the engine. Remedy: Replace the crankshaft or camshaft sensor as required.
Are there any problems with the Mazda Tribute?
Mazda Tribute/Ford Escape V6 common problems. As this model has been in Australia for over 10 years, we are now getting many tech calls relating to the Mazda Tribute/Ford Escape V6. Listed below are some common problems and remedies. Symptom 1: DFPE Sensor (Differential Pressure Feedback EGR)
What should voltage be on Mazda Tribute V6?
Check operation using scanner, oscilloscope or Multimeter. Voltage should cycle between 0.1-0.9 volts with engine speed at 2000rpm. Check for engine air leaks and exhaust leaks before the oxygen sensors.
What to do if your Mazda Tribute V6 is leaking?
To test for a leaking EGR valve temporarily block off valve with blanking gasket and recheck for lean air/fuel symptoms. Ensure the inlet manifold and plenum chamber gaskets are not leaking as air leaks in this region are also very common. Remedy: Replace the EGR valve.
Idle speed 600-700RPM and should rise to 650-750 with engine loads. Check operation with scanner or oscilloscope. Remedy: Replace the IAC valve as required. Causing rich or lean engine conditions, flat spot, hesitation and may log codes P0171, P0172, P0173, P0174 and P0175 (fuel trim limits reached), also cold start issues can occur.