Is there a recall on the Mazda B2300?
REMEDY: Mazda will notify owners that dealers will install a universal fused jumper harness on the cruise control deactivation switch free of charge. The safety recall is expected to begin on or about November 13, 2009. Owners may contact Mazda at 1-800-222-5500 option #6.
How do you change the oil in a Mazda B2300?
1. Remove the oil level plug and washer. 2. Verify that the oil is near the bottom of the plug port. 3. If the oil level is low, add the specified amount of MERCON (R) or M-III through the oil level plug hole. 4. Install a new washer and the oil level plug.
When did Mazda Bulletin E 002 / 96 come out?
BULLETIN NOTE This bulletin supersedes the previous bulletin E-002/96 issued on June 27, 1996. The APPLICABLE MODELS have been revised.
REMEDY: Mazda will notify owners that dealers will install a universal fused jumper harness on the cruise control deactivation switch free of charge. The safety recall is expected to begin on or about November 13, 2009. Owners may contact Mazda at 1-800-222-5500 option #6.
1. Remove the oil level plug and washer. 2. Verify that the oil is near the bottom of the plug port. 3. If the oil level is low, add the specified amount of MERCON (R) or M-III through the oil level plug hole. 4. Install a new washer and the oil level plug.
Why does my Mazda indicator light stay on?
The PCM will trigger the indicator light to illuminate to inform you there may be an issue with your Mazda. Occasionally, the information remains stored with your PCM, even after the issue has been fixed, and your indicator light may remain on until the PCM has been reset.
Can you reconnect the negative terminal clam on a Mazda?
Reconnect the “Negative” terminal clam on your Mazda’s battery. Based in Columbus, Ga., Ashley Hay has been covering animal health and wellness since 2004, and arts and entertainment since 2008. She holds a Bachelors of Arts in psychology from the University of Central Florida.
Where is the fuse box on a Mazda B series?
The fuse panel is located on the left-hand side of the instrument panel facing the driver’s side door. The power distribution box is located in the engine compartment. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
Why does my car have a bad MAF code?
This code is most commonly caused by a dirty, obstructed, or faulty MAF sensor, but can also be caused by issues including: Damage to the intake boot; Vacuum leaks; Clogged or improperly installed engine air filter; Clogged-up cat converter or restricted exhaust