How to know if your car has a p0717 code?
Symptoms of a P0717 code may include: 1 Intermittent or erratic speedometer (odometer) operation 2 Inability of the transmission to shift at all 3 Inoperative speedometer and/or odometer 4 Erratic or harsh transmission shift points 5 A decrease in fuel efficiency
What causes automatic transmission to not shift properly?
A faulty PCM (powertrain control module) will affect the transmission performance because it controls the gearbox mechanism in most car models. The PCM will have no input if the speed sensor fails. In that case, the transmission will not shift properly. To solve this problem, you have to check the speedometer to see…
What does p0717 input turbine speed sensor circuit no signal trouble code?
If you have a P0717 Input Turbine Speed Sensor Circuit No Signal trouble code, this post will help you understand what it is and how to fix it. The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft.
What does it mean when your car wont shift out of second gear?
To the TCM that can mean one of two things; either the sensor is bad, or there’s an internal problem with the transmission. Connect your scan tool and start the engine, leaving the transmission in PARK.
What to do if your transmission code is p0717?
Some of the most likely repairs to fix a P0717 code are: Replacing the valve body. Replacing the input/turbine speed sensor. Replacing one or more shift solenoids. Replacing or repairing damaged, shorted, or open wiring or circuits. Draining, flushing, and replacing the transmission fluid.
If you have a P0717 Input Turbine Speed Sensor Circuit No Signal trouble code, this post will help you understand what it is and how to fix it. The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft.
What is the input shaft speed of a DTC p0717?
P0717 The transmission input shaft speed is less than 50 RPM for 5 seconds. DTC P0716 and P0717 are Type B DTCs. The TCM commands maximum line pressure. The TCM freezes transmission adapts. The TCM calculates input speed from the automatic transmission output shaft speed sensor and commanded gear.
Is the body valve still p0717 after rebuild?
Decided to rebuild it, scanned before and was showing also P0717. We rebuild the tranny, replaced the ISS sensor, but still hard shifts with bangs. Went back to shop and they told me the body valve is from 2006 and they reinstalled the original one,and again hard shifts and code P0717 again !!!!