What does the OBD II fault code P2008 mean?

What does the OBD II fault code P2008 mean?

What Does Code P2008 Mean? OBD II fault code P2008 is a generic code that is most commonly defined as “Intake manifold air control actuator / solenoid, Bank 1 -open circuit”, but sometimes also as “Intake Manifold Runner Control (IMRC) Solenoid Control Circuit –Bank 1”, or less often as “Intake Manifold Runner Control Circuit/Open Bank 1”.

What does P2008 mean on an intake manifold runner?

P2008 means that the intake manifold runner circuit has an open electrical connection bank 1. The ECU tries to control the the angle of the intake manifold runner flappers and when it cannot control this circuit sets a Check Engine Light. Along with the Check Engine Light, a failsafe mode is set until normal operation resumes.

What does check engine light on Mazda 2 mean?

A check engine light can indicate a broad spectrum of problems with your 2012 Mazda 2. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.

How much does it cost to repair a Mazda p2009 intake manifold?

The cost of diagnosing the P2009 MAZDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. The engine is equipped with an intake manifold flow control valve to promote maximum air/fuel atomization.

What are the possible causes of code P2008 Ford?

P2008 FORD Possible Causes Intake Manifold Runner Control (IMRC) monitor signal shorted to power Faulty Intake Manifold Runner Control (IMRC) actuator Faulty Intake Manifold Runner Control (IMRC) solenoid Damage Powertrain Control Module (PCM) Blocked vacuum hoses What does this mean? How do I fix code P2008 FORD

A check engine light can indicate a broad spectrum of problems with your 2012 Mazda 2. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.

What does the p2009 OBD-II trouble code mean?

This code is similar to P2005, P2006, P2007, P2008, P2010, P2013 and P2015. P2009 means the intake manifold runner control circuit has excessively low voltage for bank 1. Once the ECU figures out that low voltage is present in the intake manifold runner control circuit a Check Engine Light will be triggered.

What does the code P2004 mean on a car?

What does code P2004 mean? Code P2004 stands for Intake Manifold Runner Control Stuck Open Bank 1. The intake manifold directs air into the engine via a series of runners. To improve engine performance, many late-model vehicles use what’s referred to as an intake manifold runner control (IMRC) system.