How do you turn off the ABS light on a Volkswagen?
Resetting Your ABS Dashboard Warning Light Step One: Disconnect the positive cable from your car battery. Then, hold down the brake pedal to drain the vehicle’s electrical system. This will result in a reset of the car’s central computer. Plug the cable back in to restore power.
How to Erase ABS Light Trouble Codes on a VW
- Loosen the retaining nut on the cable that runs to the VW’s negative battery terminal.
- Slide the cable clamp off the negative battery terminal.
- Wait one to two minutes. This will reset the ECU and begin the process of erasing the trouble codes.
Why does the ABS light come on on a Volkswagen Beetle?
Your Volkswagen Beetle’s ABS Light comes on when it fails a self diagnostic cycle. When on, it indicates that the Beetle does not have Anti-Lock brakes, and the safety they provide. Your Beetle’s ABS system uses a system of sensors to determine wheel speed when braking.
Why does my VW stop when the light is on?
Whilst the light is illuminated, your braking effectivness will decrease. Generally if you have this warning the problem will be a faulty ABS sensor, however do not rule out a faulty ABS pump or ABS module. To be exactly sure where the fault is, you should use the iCarsoft i908 VW OBD Code Reader kit.
Is there a warning light on the New Beetle?
VW New Beetle glow plugs warning light – the glow plug warning symbol will always light up at the ignition stage, you should always wait until this light turns off before starting the engine. This will only be seen in diesel vehicles.
Is it safe to drive a Volkswagen Beetle with the brake light on?
The brake light indicates that there is a problem with the physical braking system and that your Beetle is unsafe to drive. Yes, you can drive your Beetle with the ABS light on. Is it safe? It’s not as safe, especially when it’s raining, snowing, or the road surface is loose/uneven.