How do you remove right intermediate drive shaft in?
I suspect that you mean the right front CV axle intermediate shaft that connects the transmission to the CV axle. Basically remove the tire, axle nut, lower ball joint bolt, separate the lower ball joint from the knuckle, remove CV axle from hub, and use a pry bar to pop the CV axle from the trany.
How do you remove a drive shaft on a Mazda 3?
1. Install a spare nut onto the drive shaft. 2. Tap the nut with a copper hammer and separate the drive shaft from the axle. 3. Separate the drive shaft from the wheel hub. 4. Separate the drive shaft (LH) from the transaxle using the SSTs
Can a CV axle be removed from a Mazda 6?
This step only applies to the passenger side CV Axle. It is easiest for most people to remove the intermediate shaft and the CV axle while they are still connected to each other. Then, you can put the intermediate shaft in a vise, and hammer out the CV axle.
How to repair the front drive shaft on a Mazda CX-5?
1. Apply transaxle oil to the oil seal lip. 2. Apply grease (L2Y1 33247) to the wheel bearing inner race and drive shaft contact surface (Area A in figure). 3. Insert the drive shaft into the wheel hub. 4. Install the drive shaft to the transaxle.
1. Install a spare nut onto the drive shaft. 2. Tap the nut with a copper hammer and separate the drive shaft from the axle. 3. Separate the drive shaft from the wheel hub. 4. Separate the drive shaft (LH) from the transaxle using the SSTs
I suspect that you mean the right front CV axle intermediate shaft that connects the transmission to the CV axle. Basically remove the tire, axle nut, lower ball joint bolt, separate the lower ball joint from the knuckle, remove CV axle from hub, and use a pry bar to pop the CV axle from the trany.
1. Apply transaxle oil to the oil seal lip. 2. Apply grease (L2Y1 33247) to the wheel bearing inner race and drive shaft contact surface (Area A in figure). 3. Insert the drive shaft into the wheel hub. 4. Install the drive shaft to the transaxle.
How to replace intermediate shaft bearing without…?
The dealer does not offer the bearing, only the two dust seals. Removing the intermediate shaft is fairly simple. Remove brakes, unbolt lower control arm, then remove the cv axle after removing the nut.