When does the PassLock light work on a GMC Canyon?
It only works with PassLock when the key is in the on or start positions. With my truck, the security light flashes five times after the doors are locked with the remote, then stops. It does not continue to flash.
Why do I need to turn off PassLock on my Chevy?
People this is happening with many models of Chevy and even Hummers. It is that Passlock needs to be relearned. Key turned on then try to start but don’t let it, just crank it.
What to do if your PassLock light does not turn on?
Insert the Key into the ignition switch and try to start the car. It should start, and then stall, with the “SECURITY” light flashing. (In rare cases, the car may keep running and the security light will not illuminate, but that only happens if you are very lucky.)
How to relearn the PassLock sensor data code?
Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds . Repeat steps 1 through 4, 2 more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
Why is my PassLock not working on my 2005 Chevy Colorado?
On my 2004 Chevy Colorado 75K miles. Does anyone know if cutting this wire and thereby having the light on the dash stay on cause any problems when trying to get an inspection? I appear to be having an issue with the passlock on my 2005 Colorado I4. For the longest time, I didn’t know why my truck wouldn’t start.
Is there a problem with the PassLock sensor?
The short answer is there’s a problem with the sensor. Some have suggested that the pins in the system are “tin” plated and subject to oxidization over time. Others say their system is possessed by the devil and in need of an exorcist.
What should I do if my PassLock light does not turn on?
2. Observe that the vehicle fails to start and the passlock security light is illuminated or flashing. 3. Release key to the ON/RUN position (not the ACC position or OFF) 4. Allow the vehicle to sit with key in the ON/RUN position for no less than 11 minutes. The passlock security icon should turn off after this.
Is there a way to bypass PassLock 2?
The easiest way to bypass the Passlock 2 system is to place a resistor between the passlock sensing wire and the ground reference wire. To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel. Usually, they are orange/black, red/white, and black.