How far can a 2010 Mazda 3 go on a full tank?
Compare Side-by-Side
| 2010 Mazda 3 | |
|---|---|
| EPA Fuel Economy | Regular Gasoline |
| 27 MPG 24 33 combined city/highway city highway | |
| 3.7 gal/100mi | |
| 392 miles Total Range |
How many miles left when gas light comes on Mazda 3?
Driving Range with Low Fuel The staff at Bob Baker Mazda estimates that Mazda vehicles can travel between 30 and 50 miles after the low fuel indicator light appears.
How much does it cost to fill up a Mazda 3 tank?
The average cost for a Mazda 3 fuel tank replacement is between $1,364 and $1,431. Labor costs are estimated between $255 and $321 while parts are priced at $1,110. This range is based on the number and age of Mazda 3’s on the road.
Why does my Mazda 3 have poor fuel economy?
The gas tank is finicky. winter gas has a different vapor pressure and it’s colder so the pump clicks off earlier and doesnt actually fill the tank. I wouldn’t worry. If there’s no cel and you dont smell lots of unburnt fuel after you drive I’d say your fine.
Are there any problems with the 2010 Mazda3?
CarComplaints.com Notes: Issues with clutch failure might be giving 2010 MAZDA3 owners headaches, but the lack of support from Mazda is giving them migraines. This data is from the NHTSA — the US gov’t agency tasked with vehicle safety. Complaints are spread across multiple & redundant categories, & are not organized by problem.
Are there any problems with a Mazda hatchback?
A 2010, a 2015, and my latest a 2018 Touring Hatchback. The 2010 and 2015 was given to my kids when they needed a car. The only problem I’ve had was a motor mount replacement on the 2010 during a routine service. I didn’t even know it had a problem.
How to start a Mazda 3 refrigerant Charger?
2. Start the vacuum pump and let it operate for 15 min . 3. Verify that high– and low-pressure side readings of the manifold gauge are at –101 kPa {–1.03 kgf/cm2, –14.6 psi} . Close each valve of the manifold gauge.
What should the manifold gauge reading be on a Mazda 3?
Verify that high– and low-pressure side readings of the manifold gauge are at –101 kPa {–1.03 kgf/cm2, –14.6 psi} . Close each valve of the manifold gauge. 1. Stop the vacuum pump and wait for 5 min
How to start a Mazda 3 vacuum pump?
1. Open all the valves of the manifold gauge. Close the manifold gauge valve immediately after stopping the vacuum pump. If the valve is left open, the vacuum pump oil will back flow into the refrigeration cycle and cause a decrease in the efficiency of the air conditioner. 2. Start the vacuum pump and let it operate for 15 min . 3.