Where is the alternator regulator on a 1999 Miata?
The voltage regulator for the 1999 Miata alternator is built into the factory engine computer. We have successfully used this circuit below to regulate the alternator’s voltage. This circuit has been passed around on Miata forums for a while and we believe it was originally designed by Jason Cuadra. We’ve modified it to fit the DIYPNP proto area.
Where is the intake temperature sensor on a Mazda Miata?
Select ‘Intake Temperature Sensor’ at the top in the drop down box. (NOTE – If you are removing your MAF/AFM as a part of the DIYPNP installation process, do not recalibrate your IAT Sensor now) Enter these values, and click ‘Write to Controller’. Now click Close to Exit. Finally, you should calibrate your O2 Sensor to the ECU.
How do you calibrate a Mazda Miata engine?
You should calibrate it properly from TunerStudio in the ‘Tools’ menu. Choose ‘Calibrate TPS’. Make sure the engine is off, and the key is on. With your foot off of the throttle, click the ‘Closed Throttle ADC Count – GET CURRENT’ Button. Put the throttle to the floor.
Where are the injectors on a Mazda Miata?
Injector three is from cylinder four and injector four is from cylinder two. If you choose batch mode continue to wire the injectors as you normally would by following the jumper configuration above. The voltage regulator for the 1999 Miata alternator is built into the factory engine computer.
The voltage regulator for the 1999 Miata alternator is built into the factory engine computer. We have successfully used this circuit below to regulate the alternator’s voltage. This circuit has been passed around on Miata forums for a while and we believe it was originally designed by Jason Cuadra. We’ve modified it to fit the DIYPNP proto area.
You should calibrate it properly from TunerStudio in the ‘Tools’ menu. Choose ‘Calibrate TPS’. Make sure the engine is off, and the key is on. With your foot off of the throttle, click the ‘Closed Throttle ADC Count – GET CURRENT’ Button. Put the throttle to the floor.
What are the injector outputs on a Mazda Miata?
The injector outputs are numbered as they appear in the firing order when using the sequential injection mode. 1-3-4-2. Injector one remains the first injector, while injector two is actually cylinder three. Injector three is from cylinder four and injector four is from cylinder two.
Where does the AC input come from on a Mazda Miata?
The Input for the AC system comes in from the A/C switch on ConnectorBoard pin 1P. The output of the “Input 1” circuit gets jumpered to both 1S and 1I on the ConnectorBoard. These two pins will activate the A/C compressor clutch relay and the A/C condensor fan relay.