Why is my Mazda 323 Astina flashing hold light?
It could be that the AT needs a top up of fluid, the clutch bands or torque converter slipping or something more terminal. If left unattended, then it can continue to get worse, force the car into either ‘limp home’ mode or prevent you from driving the car.
Where is the hold button on a Mazda 323?
The “Hold” you are referring to is in regard to the Overdrive/top gear lockout. The button located on your gear lever just below the “T” This button is for holding 3rd gear when going up steep hills etc. I just verified this with our Astina. So, it’s probably just a loose wire. Hopefully! Good Luck!
What kind of engine does a Mazda 323 have?
All models were fitted either with a 1.5 or a 1.8 liter unit, or, in some cases, with a 2.0 liter V6 that was common with the Eunos 500.
What does it mean when your Astina light is flashing?
It indicates that there is a problem and this can be determined from a code that is sent out from the transmission similar to the codes generated by the engine managment system. Someone with the right diagnostic tool can read the code and usually get an idea what it is.
It could be that the AT needs a top up of fluid, the clutch bands or torque converter slipping or something more terminal. If left unattended, then it can continue to get worse, force the car into either ‘limp home’ mode or prevent you from driving the car.
Who is responsible for the Mazda 323 Astina?
To the maximum extent permitted by law, GIS and carsguide exclude all liability for any direct, indirect, special or incidental loss, damage, expense or injury resulting from, arising out of, or in connection with your use of or reliance upon this information. Interested in a Mazda 323?
What kind of car is the Mazda 323 F?
The 323 F is also known as the Astina or the Lantis in different parts of the world. The car had a different platform from the 323s. The design was handled by former Porsche designers which explains why the car has a sporty allure, with pillarless doors and distinctive sheet metal.
The “Hold” you are referring to is in regard to the Overdrive/top gear lockout. The button located on your gear lever just below the “T” This button is for holding 3rd gear when going up steep hills etc. I just verified this with our Astina. So, it’s probably just a loose wire. Hopefully! Good Luck!
Where is the engine number on a Mazda 323?
Hi . Engine identified by engine code and number . Engine code and Number are stamped on the flange at the upper rear of cylinder block deck as viewed from flywheel (transmission) side , you will need sand paper to remove any oxidation to read the stamped code .