What kind of engine does a 2010 Mazda3 have?
Buyers must make up their minds regarding engine choice: a 2.0-liter four-cylinder making 148 horsepower or a new 2.5-liter four-cylinder turning out 167 horses. The 2.0-liter powers the Mazda 3 i and carries over from the previous generation with only a few minor tweaks to improve fuel economy.
Where was my Mazda3 built?
Mazda3 Models: Mazda3 models are produced at the Japan facility in Hofu, Yamaguchi, Japan. The engine and transmission production for these models is handled by the Hiroshima plants. Mazda5 Minivan, Mazda CX-5, MX-5 Roadster, RX-8: These models are made in the Hiroshima facility in the Miyoshi ward.
Where is the compliance plate on a Mazda3?
The VIN number on your Mazda3, or any other vehicle from 1981 or later, is stamped on a thin metal plate. That plate is located on the top of the driver’s side dash, right where the windshield meets the dash.
How many Litres is a 2010 Mazda 3 gas tank?
14.5 gal. 348.0/478.5 mi.
How much horsepower does a 2010 Mazda 3 have?
Both the 2.0-liter (148 horsepower, 135 pound-feet of torque) and 2.5-liter (167 horsepower, 168 pound-feet of torque) four-cylinder engines come with variable valve timing and a two-mode composite intake manifold. If you’re looking for more punch, the 2.5-liter is the best bet.
What does p2096 mean on a Mazda 3?
P2096 is a generic OBD II code, which means that it has the same meaning for the Mazda 3 as it would any other vehicle. It specifically indicates that your 3 detected that it is running too lean (too much air for the amount of fuel present).
Why is the fuel economy on my Mazda not showing?
If there is no past fuel economy information such as after first purchasing your vehicle or the information is deleted when the battery leads are disconnected, the actual distance-to empty/range may differ from the amount indicated.
What happens to the instrument cluster on a Mazda?
When the illumination dimmer is cancelled, the instrument cluster cannot be dimmed even if the position lights are turned on. When the illumination dimmer is cancelled, the screen in the centre display switches to constant display of the daytime screen.
What causes bad O2 sensor on Mazda 3?
A bad oxygen sensor is one of the most common reasons that you’ll see P2096. You’ll need to test the sensor and determine if it is bad or good. Here’s more on diagnosing a bad O2 sensor in your 3. A clogged catalytic converter is a common cause of P2096.
Why does my Mazda 3 have a p2096 code?
My son’s ’07 MS3 had the same (or similar) code a month ago. We cleared the code and it has not returned. I figured that the throttle body may have been sticking open during cold weather and too much air got into the combustion chamber.
What to do if your catalytic converter code is p2096?
Inspect the wiring harness and connector. If a code for the Mass Airflow sensor displays check its connector. If it is alright replace the MAF sensor. Replace the oxygen sensor downstream the catalytic converter on the side of the engine with the number -1 cylinder for code P2096.
What are the symptoms of a p2096 code?
The symptoms of a P2096 code will vary depending on the component or system causing the disruption in the fuel trim. Not all will be present simultaneously. Malfunction Indicator Lamp (MIL) illumination with P2096 DTC set. Rough idle. Poor fuel economy. Poor acceleration. Misfire. Cherry red hot catalytic converter.
What causes low fuel pressure with p2096 DTC set?
Malfunction Indicator Lamp (MIL) illumination with P2096 DTC set The causes for this DTC may include: Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors. Rough running engine due to misfiring plugs.
The entry-level 2010 Mazda Mazda3 “i” is equipped with a 148-horsepower, 2.0-liter four-cylinder engine mated to either a five-speed manual or automatic transmission. The sportier “s” model comes with the 2.5-liter four-cylinder engine from the Mazda6 that pumps out 167 horsepower.
How many horsepower does a Mazda3 MPS have?
This is routed through the front wheels rather than the complex all-wheel drive system found on the Mazdaspeed Atenza. The Australian market receives the Mazda3 MPS with the same engine as the Mazda6 MPS with power output of 190 kW (255 hp). The engine was listed in Ward’s 10 Best Engines for three years straight.
What’s the top speed of a 2010 Mazdaspeed3?
From a standstill a 2010 Mazdaspeed3 can reach 60 mph (97 km/h) in 5.2 seconds, and the 1⁄4 mile (402 m) in 13.9 seconds at 102 mph (164 km/h). The suspension and steering have been changed to improve performance, most notably with the addition of electric-assisted steering.
What kind of gas mileage does a Mazda3 get?
TheCarConnection.com’s have no complaints with either transmission, but prefer the automatic’s manual shift mode for this car’s intended purpose. Fuel economy rates from 25/33 mpg for the smaller engine with the manual gearbox, to 22/29 mpg for the larger engine with the automatic–not best in class, though not bad.
What kind of car is the 2010 Mazdaspeed3?
Cars.com’s Bill Jackson takes a look at the 2010 Mazda MAZDASPEED3. It competes with the Volkswagen GTI, Chevrolet Cobalt SS and Mini Cooper S JCW. There seems to be an infinite supply of loud, little cars that have been modified to at least sound fast.
This is routed through the front wheels rather than the complex all-wheel drive system found on the Mazdaspeed Atenza. The Australian market receives the Mazda3 MPS with the same engine as the Mazda6 MPS with power output of 190 kW (255 hp). The engine was listed in Ward’s 10 Best Engines for three years straight.
Is the Mazdaspeed3 a good car to buy?
The 2010 Mazda MazdaSpeed3 has not been tested. Like what you see? Find the best deal on a Mazda MazdaSpeed3 today. There are for sale near you. Certified child passenger safety technicians conduct hands-on tests of a car’s Latch system and check the vehicle’s ability to accommodate different types of car seats.
What kind of brakes does a Mazda Speed3 have?
ABS brakes assist corner and wet-weather braking, lateral and through-ventilated disc brakes on all wheels provide extreme stopping power with reduced fade. DSC and Traction Control on all Speed3 models is also standard. The 2010 Mazdaspeed3 retained the MZR 2.3 DISI Turbo engine.