Why does my Mazda Miata make a rattling noise?
It was a clogged fuel filter. Using a screw driver as a “listening rod”, the sound can be isolated to the fuel lines running under the car. Changing out the fuel filter eliminated the tapping/rattling sound! Rod’s Mazda Miata Enthusiast’s Shop Manual has an excellent procedure for this.
What kind of oil does a Mazda Miata use?
Most lifter noise is cured by switching weights of oil. Mazda recommends trying 5W30 oil first. Some Miata owners report switching to a heavier oil like 20W50 to stop the noise. additionally, some owners report switching to a synthetic oil such as Amsoil or Redline to alleviate the noises.
Why does my Miata make a high pitch squeal?
My Miata dealer was able to isolate the problem to a vibrating purge control valve in the emissions system of the car. This valve is located in the right section (passenger side) of the engine compartment. Question: My car has been worrying me with a high-pitch “squeal” lately.
Are there any problems with my Miata shocks?
My shocks are fine, no leaks, etc. The control arm bushing could be dirty or worn and needs cleaning or replacement. In my Miata, the bushing itself was in good shape and required no replacement. The mechanic cleaned both the right and the left bushing. I paid for no parts.
It was a clogged fuel filter. Using a screw driver as a “listening rod”, the sound can be isolated to the fuel lines running under the car. Changing out the fuel filter eliminated the tapping/rattling sound! Rod’s Mazda Miata Enthusiast’s Shop Manual has an excellent procedure for this.
What’s the look of a 2009 Mazda MX 5?
The 2009 MX-5 Miata receives a mild exterior freshening featuring larger headlamps, a new five-point grille and oversized triangular fog lamp bezels. Despite the changes, the familiar Miata DNA is still evident.
What’s the difference between the old and new Mazda MX 5?
Unlike the first-generation Miatas, the newest MX-5 demonstrates a noticeable reduction in engine roughness and vibration. Past Miatas would buzz and shudder at idle, but the new MX-5 Miata hums as serenely as a happy humming bird. The 2.0-liter pulls strongly and keeps right on giving well past the 55-mph mark.
What kind of car is the 2009 Mazda Miata?
The 2009 MX-5 Miata roadster continues to capture the hearts of driving enthusiasts and open-air aficionados everywhere.
Why is my Mazda Miata bogging at 4000 rpm?
My issues were primarily below 4000 rpm, and after the engine had warmed up. Throttle response was seemingly normal across all rpm ranges with a cold engine. With a warm engine and above 4000 rpm the acceleration seemed normal. A warm engine is indicated by the O2 sensor sensing a warm exhaust manifold.
What’s the throttle response on a Mazda Miata?
This is somewhat of a common problem for this generation of Miata. My issues were primarily below 4000 rpm, and after the engine had warmed up. Throttle response was seemingly normal across all rpm ranges with a cold engine. With a warm engine and above 4000 rpm the acceleration seemed normal.
What kind of noise does a Miata make?
The noise sounds like a tapping or rattling sound that begins when the engine is started and the car is not moving. It stops instantly when the engine is turned off. At speed, the sound either goes away or is masked by road noise.
What causes a check engine light on a Miata?
This is done by opening and closing an EGR valve. The Miata’s computer calls for the valve to open and close based on a number of factors. If the computer senses that this is not being done properly (valve stuck open or closed or lines plugged), then the CEL is turned on.
Why does my Miata stop when I Turn Off the engine?
It stops instantly when the engine is turned off. At speed, the sound either goes away or is masked by road noise. It seems to be worse when the weather is cold and gets a little quieter when the car is at operating temperature.
Are there any leaks in my Miata shocks?
My shocks are fine, no leaks, etc. A: The control arm bushing could be dirty or worn and needs cleaning or replacement. In my Miata, the bushing itself was in good shape and required no replacement. The mechanic cleaned both the right and the left bushing. I paid for no parts. Return to Table of Contents
Why does my Mazda A4 make a noise when I brake?
On braking in the wet there can be a loss of braking and some noise related to this problem. Newer Mazda pads have reduced this problem. Look at the color of your pads, green are older and blue are newer (both have the same part number so ordering new pads is not easy). A4:
What kind of engine does a Mazda Miata have?
The Miata is one of the most beloved cars of our time as anybody who drives one cannot wait for another chance. It is powered by a 1.6L I4 engine that is small but spirited. Mated to the 4-cylinder is a 5-speed manual transmission.
Where was the 1990 Mazda Miata last serviced?
Last serviced at 74,015 miles in Seekonk, MA on 03/03/21 • Vehicle serviced. No accident or damage reported to CARFAX. Number of owners unknown. Last serviced in Bloomington, IL on 05/24/21 • Vehicle serviced. No accident or damage reported to CARFAX.
What kind of engine does a 1990 Mazda MX 5 have?
This 1990 Mazda MX-5 Miata 2 Door Convertible with 27K Miles features a 1.6L 4 CYLINDER 4cyl Gasoline engine. It is equipped with a 5 Speed Manual transmission. The vehicle is Marine Blue with a
Are there any problems with the Mazda MX-5 Miata?
There is one problem to watch out for if you buy a ’90. Some of them have the infamous crankshaft problem. It usually appears after the timing belt has been replaced and additional miles put on the car. Mine appeared at about 95000 miles. The problem has to do with the design of the crankshaft nose, keyway, cam drive sprocket and pulley bolt.
This 1990 Mazda MX-5 Miata 2 Door Convertible with 27K Miles features a 1.6L 4 CYLINDER 4cyl Gasoline engine. It is equipped with a 5 Speed Manual transmission. The vehicle is Marine Blue with a …
Why does my MX-5 Miata make a vibrating noise?
Some noise is common with semi-metallic brake pads. Be certain to use new brake hardware (clips and springs) when replacing brake pads. Changing to a different brand or compound of pads may help. A vibrating noise may be caused by calipers not sliding properly on the mounting brackets.
My shocks are fine, no leaks, etc. The control arm bushing could be dirty or worn and needs cleaning or replacement. In my Miata, the bushing itself was in good shape and required no replacement. The mechanic cleaned both the right and the left bushing. I paid for no parts.
What’s the lowest mileage on a Mazda Miata?
Most likely the lowest mileage manual transmission Mazda Miata for sale in the country! Fully serviced and ready to enjoy, this Mazda Miata has original miles under 22,000, with the original manuals that came with this vehicle 25 years ago!
Where does the belt go on a Miata?
The belt closest to the radiator goes from the engine to the air conditioner compressor then the power steering. Not all miatas have this belt depending on A/C on power steering. The tension in this belt comes from the air conditioner compressor pulley. The tensioner (circled) needs to be adjusted to remove the belt.
Is the MX-5 Forum part of miata.net?
MX-5 Miata Forum is part of Miata.net. If you haven’t yet visited Miata.net, or are not yet familiar with it, please go there first. There is a wealth of information and it will be very helpful to be familiar with its offerings before becoming involved in the forum. Miata.net also has a brief intro for new users.
My Miata dealer was able to isolate the problem to a vibrating purge control valve in the emissions system of the car. This valve is located in the right section (passenger side) of the engine compartment. Question: My car has been worrying me with a high-pitch “squeal” lately.
The belt closest to the radiator goes from the engine to the air conditioner compressor then the power steering. Not all miatas have this belt depending on A/C on power steering. The tension in this belt comes from the air conditioner compressor pulley. The tensioner (circled) needs to be adjusted to remove the belt.
MX-5 Miata Forum is part of Miata.net. If you haven’t yet visited Miata.net, or are not yet familiar with it, please go there first. There is a wealth of information and it will be very helpful to be familiar with its offerings before becoming involved in the forum. Miata.net also has a brief intro for new users.