What happens if you have a faulty ignition coil?
As we mentioned with the fuel economy problem, a faulty ignition coil will often lead to unspent fuel entering into the exhaust system. When this fuel comes into contact with the hot metal of the exhaust or catalytic convertor, it can instantly ignite and explode, creating a back-fire – a loud noise that booms out of the back of the car.
What happens when you replace the coil wire on an engine?
You can replace the secondary coil wire on an engine that uses one with an equal length of vacuum hose and the engine will start and run. The powerful spark will travel down the hollow hose to the distributor cap, but the engine will stall under any load because of the weakened spark.
Why does my car not start when I Turn on the ignition?
The most common causes are in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter). However, the source may also be a mechanical fault (for example, a leaking valve), or faulty components in other systems.
How does the ignition coil work in a car?
In the “start” position, the switch energizes the starter motor, and full battery voltage is directed to the coil while the engine cranks. Once the engine starts, the switch is released to the “run” position. The coil still receives voltage, but the amount may be reduced by a resistor in the “run” circuit.
What does it mean when your ignition coil is bad?
The ignition system needs to spark at the right time for the engine to ignite and the vehicle to run. Therefore when your engine experiences hard starts, it means that the ignition coils are faulty and are not delivering the required voltage to the sparkplugs.
If no, the problem could lie in the spark plug cables, the distributor (if you have one), or the ignition coil. Most modern cars do not have distributors. Instead, each plug wire has its own coil. Sometimes the coil is attached to the plug wire, other times, they are located in a block called a coil pack.
You can replace the secondary coil wire on an engine that uses one with an equal length of vacuum hose and the engine will start and run. The powerful spark will travel down the hollow hose to the distributor cap, but the engine will stall under any load because of the weakened spark.
How do you remove a coil from an ignition coil?
Use a nut driver or a small wrench to loosen the securing nuts on the coil terminals and remove the leads; the positive side of the coil has a condenser lead attached in addition to a positive lead. Then loosen the bottom clamp screw, pull out the center cable that goes to the distributor and remove the coil.