Can a crankshaft pulley be removed from a car?
If your timing belt needs to be changed or you have a damaged or worn-out crankshaft pulley, then you will need to remove the crankshaft pulley from your vehicle. There are two ways in which you can remove the crankshaft pulley. One method uses a puller kit, and the other method does not use a puller kit.
Can a crank pulley be removed without setting TDC?
Having the motor at TDC doesn’t matter if you turn the crank without moving everything else. I’m confused. Removing the crank pulley does not take the engine internals “out of time” -especially while it is sitting in your garage. With the crank pulley removed, you should be able to turn the engine (by hand) all day long without it getting stuck.
What’s the best way to break a pulley bolt?
Any feedback would be helpful and appreciated! There is a way to do it. You put a wrench on the pulley bolt and block the other end against the floor or the frame. Then you use the starter motor to turn the engine (DO NOT START IT, JUST TURN IT) for at most one or two revolutions of the crank. Just enough to break the bolt loose.
Can a pry bar be used to remove a pulley?
Alternatively, you can use a pry bar or air hammer to remove the pulley. This is a much more dangerous way to do it, so only use these particular tools if you are an experienced mechanic. Otherwise, go with the safer choice of a puller kit.
How to tighten or remove crank bolt without pulley holder?
Step-by-Step How To Tighten or Remove Crank Bolt Without a Pulley Holder Tool. Especially useful on automatic transmissions. If you Enjoy the Channel Consider helping Support it! If you have a manual trans just put it in 5th or highest gear, parking brake on, chock wheels, & have someone hold brakes & you’ll be able to torque it down.
Which is the most stubborn crankshaft pulley bolt?
Crankshaft pulley bolt is the most stubborn, highly torqued and perhaps the most challenging bolt to remove in a car.
What do you need to lock down an engine?
After the top of the engine is locked down, the crankshaft pulley bolt and tensioner pulley need to be removed. The crank pulley can be a challenge without the proper tool to hold the crankshaft in place. Crankshaft bolts are typically thread-locked and torqued between 120-180 ft.-lbs. (or more).
How to remove pulley from Toro riding mower?
How to easily remove a extremely stuck pulley from an older small engine crankshaft (8hp Briggs and Stratton from a Toro Riding lawn mower ). Before this I tried heat, a puller, air hammer and even soaked overnight in oil. Nothing made a difference. This worked however and took all of 2 minutes. Give it a shot before cutting it off.. Loading…