Is there radar cruise control on Mazda CX-5?
Mazda Radar Cruise Control with Stop & Go function (MRCC) ist available for the all-new Mazda CX-5 (if equipped). Features may vary per country. Model availability varies per country. For more information visit your official local Mazda website or select your country here: http://www.mazdamotors.eu/en/# Loading…
What should I do if my Mazda CX 5 has a warning light?
4. Start the engine and check the warning light. If the light remains illuminated even after you add oil, stop the engine immediately and have your vehicle towed to an Authorized Mazda Dealer. Do not run the engine if the oil pressure is low. It could result in extensive engine damage.
Where can I buy a new car radar?
You can buy the radar in good condition from eBay and install it. You would have to bring the car to Honda so they can readjust the radar once installed. Do you really need it?
What to do if your oil pressure is low on a Mazda CX 5?
If it’s low, add the appropriate amount of engine oil while being careful not to overfill. 4. Start the engine and check the warning light. If the light remains illuminated even after you add oil, stop the engine immediately and have your vehicle towed to an Authorized Mazda Dealer. CAUTION Do not run the engine if the oil pressure is low.
What should I do about my Mazda CX 5?
• Have the radar sensors inspected at an Authorized Mazda Dealer if any shock is applied to the rear bumper, even in a minor accident. If the vehicle is driven with a damaged radar sensor, the system may not operate properly resulting in an accident.
What is the Blind Spot Monitoring System on a Mazda CX-5?
Mazda CX-5 Owners Manual/ When Driving/ Blind Spot Monitoring (BSM) System Blind Spot Monitoring (BSM) System The Blind Spot Monitoring (BSM) system is designed to assist the driver by monitoring blind spots on both sides of the vehicle to the rear in certain situations such as when changing lanes on roads and freeways.
What does the BSM warning light on a Mazda CX 5 mean?
If the turn signal lever is operated in the direction the BSM warning light is illuminated, the system warns the driver of the vehicle in the detection area with a beep sound. A system malfunction or operation conditions are indicated by a warning.
When do you need to calibrate a forward radar sensor?
Calibration is normally required after replacement of a forward radar sensor but, may also be required after removal of front bumper/grille, after front structural repairs, or after removal and installation of the forward radar unit. Calibration can be static (in-shop) or dynamic (on-road).