What does hold button on thermostat mean?
This is where the “Hold” button on your thermostat comes into play. By pressing “Hold”, your thermostat will lock in the temperature it’s currently at until you change it again. When you are ready for your normal schedule to resume, simply press the “Run” button and return to your typical programming.
What does hold on do on Mazda Demio?
This is a performance shift mode for the automatic transmission. It prevents the transmission from shifting into the highest gear. There should be a button near or on the shifter marked “hold”. If so push it to return the transmission to normal operation.
When does the ” hold ” light come on in the dash?
(The “HOLD” indicator goes out) NORMAL for normal driving HOLD select the “HOLD” mode when starting your vehicle on a road surface slippery from snow or the like, and the vehicle will start smoothly. If you start your vehicle with the selector lever in other than the “L” position, the vehicle starts in second gear.
What does the yellow light on the dash board mean?
– CarGurus What does the yellow light “HOLD” on the dash board mean? This is a performance shift mode for the automatic transmission. It prevents the transmission from shifting into the highest gear. There should be a button near or on the shifter marked “hold”. If so push it to return the transmission to normal operation.
When to put your car in hold mode?
Normally, drive your vehicle in the “NORMAL” mode where the switch is not pressed. select the “HOLD” mode when starting your vehicle on a road surface slippery from snow or the like, and the vehicle will start smoothly.
Where is the hold light on a Mazda Demio?
There should be a button near or on the shifter marked “hold”. If so push it to return the transmission to normal operation. You’ll get better gas mileage as well. HTH. -Jim 143 people found this helpful. I change gear oil & the whole set of gear ( second hand). When i start the engine hold light disappear.After a little while it appears again.
When did the Mazda 2 dashboard warning lights come on?
Japanese car manufacturer Mazda has been producing the Mazda 2 since 1996. Also known as the Mazda Demio, the Mazda 2 is now in its 4 generation. These Mazda 2 dashboard warning lights cover mainly the Mk3 (2007-2014) and the Mk4 (2014 – present), but should also provide useful information for previous models.
What does the warning light on the dash mean?
Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults) as long as the light is on.
(The “HOLD” indicator goes out) NORMAL for normal driving HOLD select the “HOLD” mode when starting your vehicle on a road surface slippery from snow or the like, and the vehicle will start smoothly. If you start your vehicle with the selector lever in other than the “L” position, the vehicle starts in second gear.