Where are the brake lines routed in a Miata?
In a miata, because of the way the brake lines are routed, you do driver rear, then passenger rear, then the fronts. So go ahead and get the rear of the car in the air, with the wheels off. Uncap the master cylinder and get as much old fluid out as you can with a turkey baster or similar.
What’s the difference between driver rear and passenger front in Miata?
In most non-miata cars, it’s passenger rear, driver rear, passenger front, driver front. This is to bleed the brake line farthest from the master cylinder first. In a miata, because of the way the brake lines are routed, you do driver rear, then passenger rear, then the fronts.
What kind of brake fluid do I need for Miata?
If you’re tracking the car, you may want even higher-temperature brake fluid like Motul RBF600 Here’s what the rear brake pads look like in a Miata. These are Hawk HP+ brakes, which are supposed to be a dual-duty track and street pad.
Why is there grease on the brake pads on a Miata?
The grease is there to prevent rust during shipping; the rotor should never be installed in the car with grease on it. Factory Miata pads have these metal shims on the back of the pad. You’re supposed to attach it with some sort of anti-squeal compound. This is apparently to help keep noise down.
How do you remove brake pads from a Miata?
Flip open to remove brake pads, w-clips, and brake pad slide clips. Figure D – Brake pads are set aside, this shows the orientation of the slider pins, boots, and caliper body. Figure E – Turn adjuster hex in the tighten direction to drive the piston all the way out of the bore. Figure F – Infamous adjuster hex is finished for now. Dump it out.
Where do you put the dust cover on a Miata?
2) The piston dust cover is easiest to place in the cylinder first and then have an assistant (preferably with small fingers) help you expand the other end of the dust cover to accept the piston. Use a small amount of brake fluid to lubricate the process. References to first time sexual experiences are expected at this point, but not helpful.
How do you remove the piston seal on a Miata?
Carefully remove piston seal with a pick. Figure H – At the bottom of the bore is the internal c-ring. No c-ring pliers known to man fit down in the bore. Picking the c-ring out is a slightly painstaking process. With the c-ring out, remove the bolt and its o-ring seal.
What to do when your parking brake pads are replaced?
Typically, when the pads are replaced the caliper body will rotate upwards allowing access to the pads, but it will not slide back and forth allowing correct operation of the brakes (or normal disassembly for that matter). Repair is to disengage slider pin and clean, sand, buff pin.