What kind of engine does a 2002 protege es Mt have?
What year is the car and what engine did you put into it (from what year?) The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors.
Why does my Mazda Protege crank but not start?
It could be the valve timing, spark plug, fuel injection, or ignition timing. If not then it may also be a clog in the fuel line if you let it sit on a downward slope for a few days. Mine was clogged when I was on vacation and mine would crank but would not start.
Why does my Mazda Protege make no noise?
Does it start when you try jumping it. It can also be a bad starter although this will normally have a clicking noise or no noise instead of a cranking noise. It could be the valve timing, spark plug, fuel injection, or ignition timing. If not then it may also be a clog in the fuel line if you let it sit on a downward slope for a few days.
What year is the car and what engine did you put into it (from what year?) The car is a 2002 Protege ES MT, the motor is from a 2001 Protege with an AT, but the tranny shouldnt matter, I swapped flex plates and the crankshaft pulley. They were both FS-DE motors.
How much torque does a Mazda Protege have?
Tightening torque 7.9 – 10.7 N.m {80 – 110 kgf.cm, 69.5 – 95.4 in.lbf} CAUTION: Do not apply a vacuum outside the specified limits. Doing so will damage the fuel tank pressure sensor.
When to replace the relay on a Mazda Protege?
– If not as specified, replace the relay. fPage 361 fCamshaft Position Sensor: Service and Repair fCAUTION: When foreign material such as an iron chip is on the CMP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control.
What do you do when your ignition fuse blows?
I checked the fuses under the hood and found the 40 amp ignition fuse had blown. I replaced the fuse and tried to start the car. As soon as I turned the key to the start position the fuse blew again. Any ideas before I start tearing the car apart?
Why is there no spark in my ignition?
An ignition module requires some type of external input in order to activate. If your vehicle stalls unexpectedly during operation and will not start again, it is likely because of loose or corroded electrical connections in the ignition module. In this case, check the switch, clean oxidized terminals, and replace broken wires if necessary.
What to do when your engine has no spark?
Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.