What kind of engine problem does a Mazda6 have?
272-horsepower 3.7L V6 6-speed shiftable automatic FWD Check engine light; found and patched small leak. Light came back on a few days later. Check engine light. Diagnosed as a faulty valve, which was replaced. Light came back on a few days later. Check engine light. Similar diagnosis and solution as last time. Light came back on a few days later.
Why is the oil leaking in my Mazda 6?
This allowed the oil to leak when engine was cold but as the motor heated up it expanded the crimp on the metal washer so it did not leak when hot. Very displeased with the 2 dealers on their response to me about the issue.
Are there any OEM MAF sensors for Mazda6?
So far, no oem MAF sensors available for Mazda6 from parts distributors. Slight miss occurred. Replaced spark plugs Replace water pump. Dealer had said it had small crack that would worsen.
What causes the left and right axles to fail?
There is an inner and outer joint on the left and right axles. All else being equal, the outer joints fail first because they run with the highest angularity–when the wheel is turned, the joint has to redirect the torque from the engine around a corner. The more angle, the more strain.
What are the worst problems with a 2008 Mazda6?
Worst 2008 Mazda MAZDA6 Problems #1: Transmission Failure 2008 MAZDA6 Average Cost to Fix: $3,600 #2: Trunk Falls Down 2008 MAZDA6 Average Cost to Fix: N/A #3: Transmission Slips Then Clunks Into Gear 2008 MAZDA6 Average Cost to Fix: N/A
Why does my Mazda 6 not shift past 3rd gear?
I have a 2008 Mazda 6. It says solenoid 2 when put on computer. It won’t shift past 3rd. So I got a new 2nd solenoid changed it and didn’t fix it, it still doing same thing.
Is it time to move on from a Mazda6?
Donate your MAZDA MAZDA6! Is it time to move on? Support NPR & the programs you love. Donate your old car in minutes through the CarTalk Vehicle Donation Program. Click on a category below for details. Help? Loading Curious how the 2008 MAZDA6 compares to other years?
Where can I donate a 2008 Mazda 6?
Donate your old car in minutes through the CarTalk Vehicle Donation Program. Click on a category below for details. Help? Loading Curious how the 2008 MAZDA6 compares to other years?
Is there a warranty on a Mazda 6?
It was tightened but leak continued. Contacted Mazda NA Service Rep because dealer said they’d have to charge to replace oil (car is still 1 year and 12K in warranty). The Mazda Rep contacted dealer and basically told them to fix the problem under warranty. Super nice and customer oriented at the National Level.
What to do if your Mazda6 engine over heat?
Water pump belt tensioner siezed up, causing the engine to over heat. Repair included replacing the tensioner and belt as well as performing a cooling system flush.
What are the problems with a 2003 Mazda6?
2003 Mazda MAZDA6 engine problems with 56 complaints from MAZDA6 owners. The worst complaints are engine failure, oil filter cap cracked, engine blew due to no oil, and egnine knocking.
What kind of engine does a Mazda 6 have?
I have a 2003 Mazda 6 4-cylinder automatic. A few days ago it started doing a couple of odd things. First, when slowing down (as to a stop light) the engine rpm SOMETIMES doesn’t drop to idle as I approach the light. The engine wants to stay and around 1800 rpm and keep the car going.
When does the Mazda6 engine surge to idle?
First, when slowing down (as to a stop light) the engine rpm SOMETIMES doesn’t drop to idle as I approach the light. The engine wants to stay and around 1800 rpm and keep the car going. The brakes stop the car just fine, but the car wants to go. Second, when cruising at around 45 mph, the engine surges from 1800 rpm to 2200 rpm.
Why did my Mazda light not come on?
One would think that a low amount of oil in the engine would also cause the light to come on. The light never came on so this tells me that the engine should have had adequate oil for lubrication. Mazda told me that there was no correlation between the two.
Why did my Mazda 7 engine go bad?
My 7th and last MAZDA. The engine went bad. Bad knocking. Without even looking at the inside of the engine Mazda refuses to honor the warranty because, GET THIS CRAP, they require the VIN number and milage to be on the Auto Zone receipts from when I bought the oil and filters! Who has that?
One would think that a low amount of oil in the engine would also cause the light to come on. The light never came on so this tells me that the engine should have had adequate oil for lubrication. Mazda told me that there was no correlation between the two.
Why does my Mazda 6 have a low oil pressure light?
I would have to agree. The Mazda 6 I have has a low oil pressure light. One would think that a low amount of oil in the engine would also cause the light to come on. The light never came on so this tells me that the engine should have had adequate oil for lubrication. Mazda told me that there was no correlation between the two.
When did I change the oil on my Mazda 6?
I have a 2007 MAZDA 6 I bought new last spring. I have changed the oil 3 times since new and have 11,000 miles on the car. My 7th and last MAZDA.
How does Mazda high beam control system work?
Start by turning the headlight switch to AUTO. Then, push the headlight lever forward. This will place it in the high beam position. To determine if the system has actually turned on, turn your eyes to the instrument panel. You should see a green headlight icon with an “A” to indicate that the system is indeed turned on.
Are there any problems with the Mazda 6?
Problems started after 6 months (10K miles) of ownnership. full 2007 Mazda Mazda6 review Far too many horror stories about the engine throwing a rod, with or without modifications. Also, many turbos are known to smoke, but Mazda does nothing about the situation. full 2006 Mazda Mazda6 review
Is the Mazda6 a reliable car to drive?
The car has been very reliable full 2008 Mazda Mazda6 review One rear shock started leaking at about 85k, which necessitated replacing both of course. The engine stumbles sometimes when accelerating from a steady criuse – can hear what I presum is the waste gate banging like a machine gun.
When did the Mazda6 rear shock start leaking?
One rear shock started leaking at about 85k, which necessitated replacing both of course. The engine stumbles sometimes when accelerating from a steady criuse – can hear what I presum is the waste gate banging like a machine gun. No error codes and the Mazda dealership I go to has no clue as far as I can tell.
Why does my Mazda 6 make a pulsating noise?
It’s most noticeable when I need to accelerate quickly, like when merging onto the highway. Instead of smoothly raising it’s pitch, the engine makes a pulsating noise and struggles until the car reached the intended speed.
What was the problem with my 2004 Mazda 6?
The contact owns a 2004 Mazda 6. while driving 30 mph, the vehicle stalled without warning. The vehicle was towed to an independent mechanic and the battery was replaced, but the failure recurred. The vehicle was towed to a dealer where it was diagnosed that the oil needed to be changed and the starter needed to be replaced.
Why is the oil leaking out of my Mazda 6?
The oil leaks out of the faulty seals on the timing chain cover in front of the passenger, and the oil drops onto the catalytic converter. This oil vaporizes and that vapor enters the cabin in slow speed driving and when stopped at intersections.
Why does my Mazda 6 have white smoke coming from the hood?
The contact owns a 2004 Mazda 6. while driving at an unknown speed, the contact smelled a burning odor and noticed white smoke coming from the hood of the vehicle and inside the vehicle. The contact turned off the engine and the smoke disappeared.
272-horsepower 3.7L V6 6-speed shiftable automatic FWD Check engine light; found and patched small leak. Light came back on a few days later. Check engine light. Diagnosed as a faulty valve, which was replaced. Light came back on a few days later. Check engine light. Similar diagnosis and solution as last time. Light came back on a few days later.
What to do when cylinder head is removed from Mazda 6?
The cylinder head and the camshaft caps are numbered to make sure they are reassembled in their original position. When removed, keep the caps with the cylinder head they were removed from. Do not mix the caps. Loosen the camshaft cap bolts in several passes in the order shown. Loosen the cylinder head bolts in several passes in the order shown.
This allowed the oil to leak when engine was cold but as the motor heated up it expanded the crimp on the metal washer so it did not leak when hot. Very displeased with the 2 dealers on their response to me about the issue.
What should I do to my Mazda 6?
TIMING CHAIN REMOVAL/INSTALLATION Warning Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spill FRONT OIL SEAL REPLACEMENT 1. Disconnect the negative battery cable. 2. Remove the spark plugs.
When does a Mazda 3 engine stop stalling?
After about two days (two-three drive cycles) mine stops stalling and operates as normal. It’s just the computer relearning the car. Your fuel injectors are fine, if there was a problem with you’d also notice it while driving and not just at idle. Good call on the fuel injectors.
I would have to agree. The Mazda 6 I have has a low oil pressure light. One would think that a low amount of oil in the engine would also cause the light to come on. The light never came on so this tells me that the engine should have had adequate oil for lubrication. Mazda told me that there was no correlation between the two.
I have a 2007 MAZDA 6 I bought new last spring. I have changed the oil 3 times since new and have 11,000 miles on the car. My 7th and last MAZDA.
What was the problem with the Mazda engine?
The lawsuit says that the company determined that the variable valve timing assembly problems were caused by inadequate or improper hardening of the components when they were first manufactured and attempted several times to fix the problem.
170-horsepower 2.5L I4 5-speed shiftable automatic FWD 272-horsepower 3.7L V6 6-speed shiftable automatic FWD Check engine light; found and patched small leak. Light came back on a few days later. Check engine light. Diagnosed as a faulty valve, which was replaced. Light came back on a few days later. Check engine light.
So far, no oem MAF sensors available for Mazda6 from parts distributors. Slight miss occurred. Replaced spark plugs Replace water pump. Dealer had said it had small crack that would worsen.