What are the symptoms of a P2004 engine code?
Symptoms of a P2004 code may include: 1 Reduction in engine performance, especially at low RPM levels 2 Diminished fuel efficiency 3 Engine surge
What does P2004 stand for in OBD II?
A stored code P2004 in your OBD II equipped vehicle means that the powertrain control module (PCM) has detected that the intake manifold runner control (IMRC) actuator for engine bank one is stuck in the open position. Bank 1 denotes that the problem has occurred in the bank of the engine that contains…
What was the code for the P2004 intake manifold runner?
2009 Doge Journey SE, 2.4L V4 with 87000 miles Code 1 � p2004 “Intake Manifold Runner Control Stuck Open Bank 1” – I replaced the intake manifold runner control valve. It was relatively easy. 3 bolts and 1 connector.
What do I need to diagnose a P2004?
When attempting to diagnose a code P2004, a diagnostic scanner, a digital volt/ohmmeter (DVOM), and a reliable vehicle information source such as All Data DIY will be required. Check technical service bulletins (TSB) for the particular symptoms, stored code/s, and vehicle make and model before beginning your diagnosis.
What does the code P2004 mean on a car?
What does code P2004 mean? Code P2004 stands for Intake Manifold Runner Control Stuck Open Bank 1. The intake manifold directs air into the engine via a series of runners. To improve engine performance, many late-model vehicles use what’s referred to as an intake manifold runner control (IMRC) system.
What does code p2005 mean on engine vacuum?
Note: It’s also a good idea to check the vacuum hoses on system that’s controlled by engine vacuum. P2005: Code P2005 indicates the PCM determined the bank 2 IMRC actuator is stuck in the open position. P2006: Code P2006 indicates the PCM determined the bank 1 IMRC actuator is stuck in the closed position.
2009 Doge Journey SE, 2.4L V4 with 87000 miles Code 1 � p2004 “Intake Manifold Runner Control Stuck Open Bank 1” – I replaced the intake manifold runner control valve. It was relatively easy. 3 bolts and 1 connector.
What causes a P2004 code to pop up?
Code P2004 is typically caused by one of the following: Sometimes P2004 can pop up in error. Clear the code and see if it returns. If it does, the next step is to perform a visual inspection. A trained eye can check for issues such as broken wires and loose connections. If a problem is found, it should be repaired and the code cleared.