What to do with broken radio controlled toys?
Super glue and a little paint will do wonders. In fact, broken plastic internal parts can sometimes be fixed with a drop of glue. And if the damage is purely cosmetic, covering up with paint or decals can give an old RC new life. For a complete overhaul, remove the body.
What should I do if my RC radio doesn’t work?
If the RC doesn’t work right out of the box and you’ve checked the frequency, batteries, and antenna then pack it up and return it. It’s possible that there was a problem during manufacturing or it was damaged during shipping. Take it apart and fix it. Photo by M. James
Do you need radio control for a boat?
If your model boat is not just for show, but for driving or racing, you’re going to need some radio control. With our two part transmitter and receiver control sets, you can install a radio transmission into any movable model you have created and radio control steering and speed.
What’s the best way to fix a broken RC?
In fact, broken plastic internal parts can sometimes be fixed with a drop of glue. And if the damage is purely cosmetic, covering up with paint or decals can give an old RC new life. For a complete overhaul, remove the body. Scrub it down.
How to fix a broken aperture control unit?
With the aperture control unit assembly removed, remove aperture control unit motor from the assembly. Then remove the bottom of the housing for the contact gear. Finally, access broken plastic post that retains contact on the gear and replace the broken post with appropriately sized screw (a very tiny and short screw will be needed).
What to do if your Mini Cooper Stereo is not working?
Remove the screws on the side trim along the radio. Pull the center console and side trim loose, then pull out the side trim. Remove the two screws on the sides of the head unit, then pull the head unit out. Disconnect the wiring harness and pull out the fuse. Check the fuse and replace it if it’s not working.
What to do if your Mercedes COMAND control knob is broken?
Save money by simply replacing the broken plastic shaft with a new aluminum version of it. You can replace the broken shaft yourself or send your Mercedes COMAND unit to a company such as IE Works, which will repair your unit and return it to you. Here is a link where you can order their service: Mercedes COMAND Broken Shaft Service on eBay
What should I do if my Screw Conveyor is failing?
This will lead to frequent conveyor maintenance and downtime, higher overall operating costs, and the equipment’s premature failure. One common method for combating these problems is to use abrasion-resistant plate or hard surfacing on the trough and screw.