How many miles do lexus LS400 last?
Not many cars will ever get past 500,000 miles, but this Lexus LS400, on its entirely original engine, isn’t far short of racking up one million.
How do you read the Diagnostic Code on a Lexus LS400?
1) In order to read the code the battery must be 11v or higher, throttle valve fully closed, transmission in neutral position, and AC turned off. For checking transmission codes the OD switch must in on (pushed in). Connect terminals Te1 and E1 by placing a short piece of wire in the TDCL diagnostic port under the steering wheel.
What is the idle signal on a Lexus LS400?
45 – When idle switch is ON, main throttle position sensor signal is 1.5V or higher 46 – Main throttle position sensor signal is 4.3V or higher, or main throttle position sensor signal is 0.2V or lower when idle switch is OFF 47 – When idle switch is ON, sub-throttle position sensor signal is 1.45V or higher
Where do you put the jumper wire on a Lexus LS400?
For engine and transmission codes you place the jumper wire in Te1 and E1. For air bag codes, ABS and TRAC codes, you place the jumper wire in Tc and E1.
How long does it take for a Lexus diagnostic code to be output?
Multiple codes can be output. In this case the lowest numbered code is output first followed by a 2.5 second pause between other higher numbered codes in increasing numerical order. Once all stored codes have been output there will be a 4.5 second pause and then the codes repeat.
1) In order to read the code the battery must be 11v or higher, throttle valve fully closed, transmission in neutral position, and AC turned off. For checking transmission codes the OD switch must in on (pushed in). Connect terminals Te1 and E1 by placing a short piece of wire in the TDCL diagnostic port under the steering wheel.
45 – When idle switch is ON, main throttle position sensor signal is 1.5V or higher 46 – Main throttle position sensor signal is 4.3V or higher, or main throttle position sensor signal is 0.2V or lower when idle switch is OFF 47 – When idle switch is ON, sub-throttle position sensor signal is 1.45V or higher
For engine and transmission codes you place the jumper wire in Te1 and E1. For air bag codes, ABS and TRAC codes, you place the jumper wire in Tc and E1.
Multiple codes can be output. In this case the lowest numbered code is output first followed by a 2.5 second pause between other higher numbered codes in increasing numerical order. Once all stored codes have been output there will be a 4.5 second pause and then the codes repeat.