Is there a way to bed the rotors?
Yeh, no problem. Push on the pedal and it will grab the rears slightly depending on how hard you press down. Let off and the brakes disengage right away. Great way to clean up your rotors and bed the rear pads also. Try it sometime. Epricedright!
What kind of brake pads do Raybestos PG plus use?
So anyhow, new Raybestos PG Plus rotors and Raybestos Quiet Stop ceramic pads did the trick…no more vibration! BTW, good thing I bought the brake caliper piston CUBE tool to screw in the piston as needle nose pliers would have taken forever, never mind possibly cutting into that rubber piston boot.
What’s the best way to clean your rotors?
Push on the pedal and it will grab the rears slightly depending on how hard you press down. Let off and the brakes disengage right away. Great way to clean up your rotors and bed the rear pads also. Try it sometime.
Do you need to replace your brake pads and rotors?
But sometimes, it is very possible to lubricate and release the stuck caliper pins. And in other cases, you need to replace the calipers completely. Also, it’s likely that you will need new brake pads and rotors. Whenever there is a brake job done on your car or replace a brake pad, you must replace the shims.
What causes brake noise after new rotors and pads?
One of the major cause of brakes noise after new pads and rotors is having excess brake dust that is trapped between the caliper and the rotor.
Yeh, no problem. Push on the pedal and it will grab the rears slightly depending on how hard you press down. Let off and the brakes disengage right away. Great way to clean up your rotors and bed the rear pads also. Try it sometime. Epricedright!
So anyhow, new Raybestos PG Plus rotors and Raybestos Quiet Stop ceramic pads did the trick…no more vibration! BTW, good thing I bought the brake caliper piston CUBE tool to screw in the piston as needle nose pliers would have taken forever, never mind possibly cutting into that rubber piston boot.