How do you reset the maintenance light on a 2007 Lexus ls460?
1) Switch the display to trip meter A when the engine is running. 2) Turn the engine switch OFF. 3) While pressing the trip meter reset button, set the engine switch to the IG-ON mode (but do not start the engine, otherwise the reset mode will be canceled).
How do you reset the oil change light on a Lexus?
The process is pretty simple:
- Turn the ignition on.
- Depending on your model, flip the odometer/trip display to “ODO” mode or “TRIP A” mode.
- Switch the ignition off.
- Hold down the “Trip Meter Reset” button while turning the ignition switch back on.
- The maintenance light should blink, go solid, and then turn off.
When to reset maintenance required light on Lexus LS 460?
When engine oil needs to replace, maintenance required light will appear on the display. The maintenance warning must be reset after performed the maintenance service or change the engine oil on your vehicle. Follow the instructions below to reset the MAINT REQD light on your Lexus LS 460:
How do I reset the oil change light?
While holding the “TRIP METER RESET” button, turn the ignition to the “RUN” position. Hold down button until display indicates that the reset is complete. Turn the ignition off.
When did the Lexus LS 460 come out?
Sold in France at the end of 2006 in petrol version, the LS 460 is sold from € 95,000 (Pack Executive) to € 104,000 (President’s Pack), while the LS 600h comes out in France in September 2007, to € 126,500 in ” short “and 129 500 € long version. It is restyled in 2009 and 2012.
When to reset the oil change light on a Lexus LS460?
The Oil Change Light Reset Lexus LS460 2007 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the Oil Change Light Reset procedure for the Lexus LS460 2007 .
How to reset the ” maintenance required ” light in my Lexus?
Lexus takes us through the steps in resetting that Maintenance Required Light that pops up on the Instrument Panel. Remember, this procedure should be used to reset the light when maintenance has been performed
While holding the “TRIP METER RESET” button, turn the ignition to the “RUN” position. Hold down button until display indicates that the reset is complete. Turn the ignition off.