Do you need an alignment after installing strut bar?
No, you don’t need an alignment after putting on a strut brace.
What’s the best way to install a strut bar?
Using an electric drill, carefully drill holes for the strut bar bolts. Bolt the strut bar into place with the supplied hardware. Some strut bars will be installed with a bolt and a nut; others will be installed with a nutsert, which is a threaded part that is inserted into the holes that were drilled.
Which is better front or rear strut bar?
When you place one in the rear, then there are fewer stresses to manage because the structure tends to be stiffer already. Most vehicles can skip the installation of a rear strut bar, but it can provide more stability in a car where the front one isn’t getting the job done as expected.
What should I use to clean my front struts?
Clean the strut towers with a degreaser and a clean, dry rag. Do not install the strut bar with the car sitting on jacks. It should be sitting on level ground and on all four wheels. Inspect the upper strut mounts to determine if and where the nuts or bolts for the upper struts are located.
What happens if the strut bar is too stiff?
It can make the response of the vehicle become too stiff. There are times when the strut bar doesn’t match the performance of the vehicle. In this situation, too much stability can transfer as you transfer energy to one side or the other. This disadvantage causes the car to become stiff, which means you can lose its handling rather easily.
The first step is to remove the nuts from your strut tower. Then place the bracket of the strut bar over the struts with the nuts on top. Then tighten the assembly. Do the same thing on the other side, and then adjust the bolts to the required length.
How do you install a strut tower brace?
Look at your strut mounts. There may already be drilled holes just waiting for you to install your strut tower brace. Or, you may need to break out your sharpie, measuring tape, and drill. Once you’ve figured out where your strut bar is going to attach, go ahead and set your strut bar down in what will be its new home.
What does a strut bar on a BMW do?
The Strut Bar Explained A strut bar also called a strut brace or strut tower brace is a connecting rod that laterally (from left to right) links your suspension strut towers. This reinforces your chassis by tying these two stress points together. A BMW 123i with M3 strut tower brace.
It can make the response of the vehicle become too stiff. There are times when the strut bar doesn’t match the performance of the vehicle. In this situation, too much stability can transfer as you transfer energy to one side or the other. This disadvantage causes the car to become stiff, which means you can lose its handling rather easily.