How do you replace the serpentine belt on a Lexus?
Remove the plastic covers covering the air scoop screws on both sides of the engine bay. The driver’s side has a plastic screw in it that holds it in place near the center; the passenger side will pop off. Figure 1. Remove plastic covers. Remove the air scoop held in by 10mm bolts on either side. Figure 2.
Where is the cheater bar on a Lexus?
Socket on the tensioner bolt (notice the mess caused by removing the upper radiator hose). With the cheater bar on the end, get it as close to the air intake as possible. The handle of the tool should be pointed to the passenger side of the car.
Why is my serpentine belt not working properly?
Start the motor to give the belts a quick test. Make sure everything is installed properly with no odd noises or vibrations before installing the air scoop and plastic covers. Any chirping or other out of place noises are a sign that the belt isn’t properly mounted on the pulleys.
How do you remove the serpentine belt on a Lexus ES?
Working from inside the wheel well, place the 14mm wrench or socket onto the tensioner bolt. Rotate the bolt counter-clockwise towards the front of the car. While holding it rotated, slide the 5mm hex key into the hole below it to lock it into place. Remove the wrench and remove the serpentine belt. Figure 3. Releasing tension. Figure 4.
Can you replace the drive belt on a Lexus GS?
Replacing the serpentine or drive belt in a Lexus GS or IS is a perfect DIY car project for relative novices. Like changing the oil, replacing the serpentine belt before it goes bad can save every Lexus owner an expensive headache in the future. This article applies to the Lexus IS and GS (2007-2014).
How do you put a tensioner on a car?
Working from inside the wheel well, place the 14mm wrench or socket onto the tensioner bolt. Rotate the bolt counter-clockwise towards the front of the car. While holding it rotated, slide the 5mm hex key into the hole below it to lock it into place. Remove the wrench and remove the serpentine belt.
Socket on the tensioner bolt (notice the mess caused by removing the upper radiator hose). With the cheater bar on the end, get it as close to the air intake as possible. The handle of the tool should be pointed to the passenger side of the car.
Remove the plastic covers covering the air scoop screws on both sides of the engine bay. The driver’s side has a plastic screw in it that holds it in place near the center; the passenger side will pop off. Figure 1. Remove plastic covers. Remove the air scoop held in by 10mm bolts on either side. Figure 2.
How much does it cost to replace the timing belt on a Lexus ES300?
Lexus ES300 Timing Belt Replacement costs $728 on average. Following is a breakdown of the labor and parts estimates. What is a timing belt and how does it work? An engine timing belt is a fiber reinforced, toothed drive belt manufactured using durable compounds such as highly saturated nitrile.
How do you replace the V belt on a Lexus RX 450h?
Lexus RX 450h V-belt diagram. Even if you’re only replacing the power steering belt, this belt needs to be removed to gain access to it. You’ll be working from above for this step, so you’ll need to remove the plastic covering on the top. Remove it by unscrewing the plastic screw holding each of the panels in.
Start the motor to give the belts a quick test. Make sure everything is installed properly with no odd noises or vibrations before installing the air scoop and plastic covers. Any chirping or other out of place noises are a sign that the belt isn’t properly mounted on the pulleys.