What is the p1130 code on a Lexus RX300?
Hello and thank you for using just answer. The p0125 is a code for insuffecient coolant temperature during closed loop control. P1130 and 1150 are for performance malfunctions in BOTH the air fuel ratio sensors. These are all overlapping codes.
What do you need to know about Lexus troublecodes?
If light remains on, the self-diagnosis system has detected a fault in the system. Battery voltage must be 11 volts or more. Throttle valve must be fully closed. Transmission must be in Neutral position.
Where is the data link on a Lexus SC300?
Throttle valve must be fully closed. Transmission must be in Neutral position. All accessories must be turned Off. On pre-OBD II models, turn ignition to On, then use a jumper wire to connect terminals TE1 and El of the data link connector, located under the left hand side of the instrument panel.
How much does it cost to repair a Lexus p0125?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P0125 LEXUS code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type.
What does the ECT mean on a Lexus p0125?
The ECT is 0u0002C (32u0002F) at engine start. After 5 minutes running time, the ECT sensor still indicates that the engine is not warm enough to begin active feedback control of the air-fuel ratio. The ECM interprets this as a fault in the sensor or cooling system and sets a DTC.
What do the p0125 and p1130 codes mean?
The p0125 is a code for insuffecient coolant temperature during closed loop control. P1130 and 1150 are for performance malfunctions in BOTH the air fuel ratio sensors. These are all overlapping codes. The 125 can cause the other 2 codes or the 1150 and 1130 can cause the 125 code to set……sorry I’m trying to keep this simple.