How to reset Lexus LS430 VSC light and others?
7; replace paperclip this time in 3 and 4 pins as before but, moving one across the top to 3 but using 4 on the bottom 9; now watch as all the abs, eml, vsc, sport, ride height everything flash on and off. Again let it do this for a couple of minutes.
How do I Turn Off the VSC reset light?
When the TRAC is off, then the TRAC OFF indicator lights turn on. If you want to turn off both TRAC and VSC, then press hold the button for few seconds (3 seconds approximately); this way, both the indicators of TRAC OFF and VSC OFF will be seen. In the same way, you can turn on both by pushing the button again.
Where is the diagnostic socket on a Lexus LS430?
There are two rows of holes. The paper clip goes in the holes on the top row for the first step. Then one on the top row and one on the bottom row for second step. Top row is one closest to steering wheel. Second tip. It is very hard to crawl upside down to look up at diagnostic socket.
What causes the VSC light to come on?
It is known for its high safety standards. When the vehicle stability control system is impeded, it causes the VSC light to come on on the dashboard. This warning light, appearing on your vehicle’s dashboard, can be reset by following few simple steps. How to reset the VSC light?
Where is the VSC light on a 2003 Lexus LS430?
I have a 2003 LS 430 (USA) with 186,000 miles. I recently had the alternator replaced and that’s when the VSC light came on. Some added tips. There are two rows of holes. The paper clip goes in the holes on the top row for the first step. Then one on the top row and one on the bottom row for second step. Top row is one closest to steering wheel.
Where is the VSC off and check engine light?
Friday after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control (ETS) light stayed on and right next to it on the left side the “VSC Off” light kept blinking and flashing.
There are two rows of holes. The paper clip goes in the holes on the top row for the first step. Then one on the top row and one on the bottom row for second step. Top row is one closest to steering wheel. Second tip. It is very hard to crawl upside down to look up at diagnostic socket.
What should I do if my VSC light keeps blinking?
MY SOLUTION; 1. Turn car completely off. 2. Take keys out of ignition 3. Before exiting your car, in order, pop your gas cap open then pop your hood. 3.