Why is there no power on purple wire in start position?
If there is no ground getting to the starter relay then the computer is not energizing it. Typically when this occurs it is due to the computer not receiving a signal from the ignition switch or from the transmission position sensor.
What causes the camshaft sensor to send the wrong signal?
A worn-out belt can prevent the Crankshaft – Camshaft Position Sensor from synchronizing, causing the sensor to send the wrong signal. So your car was running fine, but suddenly it’s, stalling, jerking, idling poorly, surging, or just running poorly.
What kind of diagnostic pinout does a GM car use?
Most GM cars produced in 1996-2003 use J1850-VPW interface. GM cars produced in 2003-2006 use J1850-VPW interface or CAN. Most cars produced after 2006 are equipped with CAN bus. Since 2002, there is another pinout – GM-LAN (for vehicles equipped with CAN bus)
Is there a problem with the Honda CRV display?
Was able to capture in person at the dealer and they replaced the display in 2018. But it later started the same flashing and cycling again even with the new unit. Caught it on video and brought back to dealer, who researched and in March 2019 said there was a tech line bulletin on it, but there was no known fix yet.
Why does my Honda CRV have a black screen?
I took a video to show the Honda dealer maintenance rep (who claimed that he had never heard of this problem before). They replaced the audio unit and it seemed to to better for a short time until the screen and radio failed completely (just a black screen).
What to do if your CB radio has no power?
CB Radio Has No Power. No lights come on the radio. There is also no sound. You cannot transmit or receive. Check Power Cord Connections. Make sure the power cord connections are attached correctly. If your radio has a power plug, make sure it is seated well. Check Fuse. Make sure the CB radio’s fuse is not blown and that it is seated correctly.
Why does my Honda CRV have no power?
I jump started it and work. mirror light might be the culprit. Thanks ED926, I would definitely check with dealer on this. Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus.
If there is no ground getting to the starter relay then the computer is not energizing it. Typically when this occurs it is due to the computer not receiving a signal from the ignition switch or from the transmission position sensor.
How can you tell if a fuse is blown on a Honda CRV?
Determine from the chart, or the diagram on the fuse box lid, which fuse or fuses control that device. Check those fuses first, but check all the fuses before deciding that a blown fuse is the cause. Replace any blown fuses, and check if the device works.
What to do if rear hatch on Honda CRV does not open?
1. Measure the resistance from terminal E20 to ground. I removed the actuator last week and measured its resistance and it was 7 Ohms. I expect a measurement slightly more than this. 2. Measure the resistance from terminal E13 to ground while pressing the Tailgate Outer Handle Switch.
Why does my GM car say no start no crank?
How to diagnose a no start no click on GM vehicle. If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that.
What is a typical GM starting system wiring diagram?
Click on the image here to pull up a PDF of a typical GM starting system wiring diagram. Depending on the year, model and engine of your GM vehicle, your starting system may be less complicated or use only some of the components shown here. For example, earlier anti-theft systems didn’t communicate the same way with the PCM.
Why does my car not start when I put it in neutral?
Today, even putting in neutral after using the shift lock release, the car still has no power and will not start. I do not think it’s a battery issue, but now my car is stuck on the third floor the parking garage in my apartment building and I have no idea how to at least get it to turn on to take to a mechanic.
What causes the spark plugs to not work?
Oil on the spark plugs can come from a failed seal, or it can come from a failed valve cover gasket. The spark plug well seals you are referring to can be changed. It is a slightly lengthy process to… My 3rd brake light still works but not lower lights, cruise will not set.
What to do when your car won’t start?
When I went to turn on the car, all power died from the car and nothing would happen when I turned the key. I wiggled the steering wheel and tried to put the car in neutral using the shift lock release and the power came back on and I was able to start it.
Where does the purple wire go on a Powermaster starter?
The way it goes is the purple wire comes from the ignition switch to the starter solinoid terminal S (you have to have that wire or it will not crank) the yellow wire goes stock to the second small terminal I, it sends power to the coil while cranking but becomes a dead end once the start is disengaged.
Today, even putting in neutral after using the shift lock release, the car still has no power and will not start. I do not think it’s a battery issue, but now my car is stuck on the third floor the parking garage in my apartment building and I have no idea how to at least get it to turn on to take to a mechanic.
How do I get 12 volts from my starter?
Ok just got back from under car. Putting respecter to red cable bat and black meter to black ground get 12 volts,touching the other two red wires which are on the same screw the main red from battery get 12 also. That is all the wires attached to starter!
What is the purple wire on a Chevy Silverado?
It is the small wire that attaches to the solenoid. It is the purple wire. You can also just cross the purple wire at the starter with the battery cable and see if the starter will turn over. If not then check the battery connection at the starter.
How to test a starter without having to touch the starter?
How To Test A Starter Without Having To Touch The starter. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
Where does the yellow wire go on the ignition switch?
Small yellow – power at crank. Small white – power on with key for accessories. Traced yellow wire to relay on fuse box. Trips relay. Has power. Still no power at crank fuse. By the diagram, the yellow wire goes from the ignition switch to the I/P fuse box where the crank fuse is. (It shows no relay) The wire goes directly to the crank fuse.