How do you reset the tire pressure light on a Lexus LS460?

How do you reset the tire pressure light on a Lexus LS460?

  1. Park the car in a safe spot and turn the engine off.
  2. Fill the tires to the appropriate air pressure.
  3. Turn the engine switch to Ignition On mode.
  4. Press and hold the reset switch until the tire pressure warning light blinks slowly three times.
  5. Wait a few minutes, and then turn the engine off.

How to reset tire pressure light on 2007 Lexus LS460?

LS460 / LS600H (2007-2017) Tire pressure reset process cannot be done while the vehicle is moving. Look for the TPMS reset button and press the button until the tire pressure indicator Blinks slowly three times.

Where do I find the tire pressure on my Lexus?

Using a tire pressure gauge, either manual or digital, check your vehicle’s tire pressure. You can find the recommended tire pressure level for your Lexus in the owner’s manual or in a tire placard located in the vehicle’s door edge, door post, or glove compartment. You can also check your PSI recommendation on the tire itself.

What should the pressure be on a SL tire?

The maximum allowed pressure listed on a tire’s sidewall can be higher however. Some tires list 44 psi and many higher speed tires will list 50-51 psi. This added pressure does nothing for load capacity. Pressures above 35-36 psi for SL tires and 41-42 psi for XL tires will not increase the load capacity of the tire.

Where do I find the tire pressure label?

Inside the service manual book, there is often information of where to find the tire pressure label. The most common place is on the chassis, behind the driver door and sometimes at the location of the spare tire. It will look something like this:

What should the pressure be on the door tag?

The manufacture recommended pressure on the door tag is 32 PSI for the front and 28 PSI for the rear. I also checked the tires on our “new” 2010 Pontiac Vibe as well.

Where is the pressure sticker on my car?

There is extra pressure in warm tires, so tire pressure should be measured while your tires are cold. You can compensate for this extra pressure, but it won’t be as accurate as the cold weather inflation pressure recommended on your placard. The tire pressure sticker is usually located on the drivers side door jamb, near the VIN label.

What should I put on my tire pressure sticker?

Your tire pressure placard may also indicate summer tire pressure, comfort tire pressure, performance tire pressure, vehicle loading information and speeds. The tire pressure sticker can also contain what tire pressure monitoring system is on board, wet or dry tire conditions, number of occupants and even how often to re-torque wheels.

What should the tire pressure be on the door?

You should only use what is on the Door…Never use the max pressure on the tire sidewall. If you looked closer you would have also noticed a weight. So it probably said 51 PSI @ 2000lbs. So you’d want to put the tire at 51 PSI if your vehicle weighed 8000lbs (2000 x 4). I usually set my tires a couple of lbs over the stated pressure in the door jam.

The manufacture recommended pressure on the door tag is 32 PSI for the front and 28 PSI for the rear. I also checked the tires on our “new” 2010 Pontiac Vibe as well.

Posted In Q&A