What can cause P0325?

What can cause P0325?

Causes of Code p0325

  • Faulty sensor 1 Bank 1 knock sensor.
  • Engine is running excessively lean.
  • Faulty or damaged knock sensor wiring.
  • Engine coolant system fault.

What are the causes of code p0330?

Causes of Code P0330 Faulty sensor 2 Bank 2 knock sensor Engine is running excessively lean Faulty or damaged knock sensor wiring

What is the knock sensor code on a Lexus ES300?

Since the code is stated to be a short/open circuit between the sensor, indicating the sensor or wiring is bad, I checked to make sure all of my connections were good. I picked up two knock sensors and the wiring harness from Orielly’s, Import Direct.

How to test Toyota p0330 knock sensor codes?

Use a baer copper wire so you can get your test probe on it. Don’t short out the wires. Then put your multimeter on an AC setting and see if there is about 250mV or so. If you have a scope, that would be even better. 7.1KHz is a low frequency, but just see if you’re in the ballpark on both sensors.

When does the p0325 knock sensor code show up?

Now I get P0325 after about two hours of the car running. Since I commute about an hour, it happens halfway through the way home from work. ( I reset the code when I get home) A cold start, followed by an hour of freeway driving, followed by a cold start hours later, then about 30 minutes on the rode and the code will show up.

Causes of Code P0330 Faulty sensor 2 Bank 2 knock sensor Engine is running excessively lean Faulty or damaged knock sensor wiring

Since the code is stated to be a short/open circuit between the sensor, indicating the sensor or wiring is bad, I checked to make sure all of my connections were good. I picked up two knock sensors and the wiring harness from Orielly’s, Import Direct.

Use a baer copper wire so you can get your test probe on it. Don’t short out the wires. Then put your multimeter on an AC setting and see if there is about 250mV or so. If you have a scope, that would be even better. 7.1KHz is a low frequency, but just see if you’re in the ballpark on both sensors.

Now I get P0325 after about two hours of the car running. Since I commute about an hour, it happens halfway through the way home from work. ( I reset the code when I get home) A cold start, followed by an hour of freeway driving, followed by a cold start hours later, then about 30 minutes on the rode and the code will show up.