How to replace the serpentine belt on a Lexus ES300?
How to Replace the Serpentine Belt on a Lexus ES300. 1 Step 1. Open the hood on the Lexus ES300 and look for the serpentine belt routing diagram. The diagram on the Lexus ES300 will show the serpentine 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.
How do you remove the belt on a Lexus RX?
Try to squeeze the belt together in the middle, which should cause the pump to rotate up and release the tension. Otherwise, you’ll need to use a cheater bar and a screwdriver or something similar to pry up the pump. Once the pump is rotated up, you can remove the belt.
What is the control arm on a Lexus GS300?
Control Arm with Ball Joint Assembly, Rear Upper Passenger… Control Arm with Ball Joint Assembly, Rear Upper Driver Side… Control Arm With Ball Joint Assembly Front Upper Driver and…
Can you replace the drive belt on a Lexus GS?
Replacing the serpentine or drive belt in a Lexus GS or IS is a perfect DIY car project for relative novices. Like changing the oil, replacing the serpentine belt before it goes bad can save every Lexus owner an expensive headache in the future. This article applies to the Lexus IS and GS (2007-2014).
Where does the serpentine belt go on a Lexus RX?
This article applies to the Lexus RX (2007-2014). Traditionally, a serpentine belt goes around all the different pulleys on the front of the motor, thus giving it it’s name from the serpentine route it takes. However, the Lexus RX’s are a bit different and have two different belts: one for the power steering and one for the alternator.
Where to put a new power steering belt?
Figure 8. Power steering belt bolt locations. With the pump still rotated up, it should be easy to slip the new belt on. Getting the pump back into place to hold tension on the belt can be tricky and usually requires prying it back down. Once the belt is on, you’ll need to make sure it has proper tension on it.
How to change the front tire on a Lexus RX 300?
The older RX 300 and RX 330 guides will follow. Loosen the lugs on the front wheel and put the vehicle on jack stands. Finish removing the lug nuts and remove the wheel. (Related Article: How to Change a Tire – ClubLexus.com)
When did the Lexus ES300 come out?
The Lexus ES300 was a mid-size entry level luxury sedan from Lexus between 1992 and 2003. Although, it?s styling and personality was not remarkable, but it was the car most consumers test drove, when they wanted to buy a Lexus car.
Slide the serpentine belt off the tensioner pulley with your other hand. Release the tensioner. Slide the belt off the remaining pulleys and remove the belt from the engine compartment. Slide the new serpentine belt into the engine compartment and route the belt around the crankshaft pulley first.
Where is the tensioner on a Lexus ES300?
The tensioner on the Lexus ES300 is located in the center of the engine. The tensioner has a pulley on one end that the serpentine belt is routed around and a spring-loaded arm on the other end. There is a 15mm bolt head in the center of the tensioner.
Why do you need tensioner on serpentine belts?
Both are used to keep tension on the engine serpentine belts so that they can drive the various engine accessories. When the tensioner has an issue, it can affect the how the belts drive the pulleys which can affect the performance and functionality of the vehicle.
What happens if you loose a drive belt tensioner?
Many of the engine’s accessories, such as the alternator, water pump, and AC compressor, can be belt driven. A seized or loose drive belt tensioner can cause the belt to snap, which will disables those accessories and can cause problems such as overheating, a dead electrical system and battery, or a disabled AC system.