What happens when front struts are worn out?
When struts are wearing out, it can cause damage to the tires. The struts are a critical component impacting suspension alignment. If damaged, they can cause the front-end alignment to be “off” — which can cause tires to wear more on the inside or outside edges. 6. Poor braking performance.
How often should front suspension and struts be inspected?
Have your struts and suspension inspected every 25,000 miles or when you notice premature tire wear. Most automotive mechanics suggest having the front suspension components inspected every 25,000 to 30,000 miles.
Where are the shock absorbers and struts located?
Strut suspension usually has the shock absorber and the spring in one unit, with the top of the strut mounted very high in the car body and the bottom of the strut attached to the lower control arm. This lowers the vehicle center of gravity, which is a good thing.
Do you need an alignment after replacing shocks?
In general, you’re less likely to need an alignment after replacing shocks. But there are exceptions to that generalization. For example, most automakers recommend performing an alignment on cars that use a short/long-arm front suspension (the design houses the shock inside the spring).
What causes rear sway bar to come loose?
Rear Sway bar bushing (inside ones )came loose and caused a thump/rattle in the rear. Dealer had to install completely new bar to repair and thought a redesign of this part was needed in the future. front end feels loose.
Why does my Lexus strut make a clunking noise?
As I rule I usually replace the bearings and mounts when doing struts. Toyota/Lexus has had issues with both the bearings and towers making noise. Take a look at the spring and its orientation to the insulators, any sleeves on the spring wire and spring seats top and bottom.
Why is there a white mark on my strut mount?
The strut mount is on an angle, if it is not installed in the vehicle with the correct orientation the bottom of the strut mount will rub on the upper spring bracket. The white paint mark on the strut mount is a reference mark, I believe the white mark faces outward, compare it with the other side.