How do you install a water pump on an alternator?
Loosen the alternator tension adjusting bolt (A) to loosen tension. 3. Remove the drive belt (A). 4. Remove the water pump pulley (A). Tighten the bolts diagonally when installing. 5. Remove the water pump (A). Install the water pump with a new gasket. 6. To install, reverse the removal orders. 7. Fill with engine coolant. 8.
How to replace water pump on Johnson Evinrude 85?
Wholesale Marine How To Video Guide. Installing a new water pump impeller kit that fits the following Johnson & Evinrude Outboard engines: 85, 90, 100, 120, 125, 135, 140, 150, 175, 200, 225, 235, 300, V4, V6, V8, and Sea Drives. Loading…
How does a lower unit water pump work?
Mate the lower unit with the upper exhaust housing making sure the drive shaft goes in it proper guide hole and simultaneously guide the water tube into the rubber grommet on the water pump housing. Once the driveshaft reaches the bottom of the power head, rotate the flywheel to align the splines on the powerhead to that of the driveshaft.
How to remove a water pump from a Kia Rio?
3. Remove the drive belt (A). 4. Remove the water pump pulley (A). Tighten the bolts diagonally when installing. 5. Remove the water pump (A). Install the water pump with a new gasket. 6.
How do you remove a water pump housing?
Using a 10 mm wrench, remove the four 6x50mm washer bolts attaching the water pump. Gently pry the pump housing and remove it from the vertical shaft. Clean all parts and check the impeller, liner, and cover for wear or cracks. Use the service kit [1] if only the impeller is worn.
How do you install a water pump impeller?
Install the impeller by turning it counterclockwise into the impeller liner. Make sure the open end of the keyway is visible and will face out when installed in the pump. Align the boss of the impeller liner and insert into the groove of the impeller housing. Insert a new greased O-ring and water tube seal ring into the impeller housing.
How to replace a water pump on a boat?
Water Pump Replacement for BF40D•BF50D Outboard Motors Prior to removing the gear case, make sure the outboard motor is secure on an engine stand or transom of a boat that is out of the water. Tilt the outboard motor up to the highest position and place the shift lever in the “R” (reverse) position. DISASSEMBLY 1.
What do you do when you replace a well pump?
Turn on a hose or faucet to release all the pressure from holding tanks or pressure tanks by letting the water drain out. When you install a new pump, you need to drain the water from the pumping system. Use a plumber’s wrench to take off the inlet and outlet ports on the old well pump.