Can you turn off the seat belt buzzer on a Lexus?
If you are looking to turn off the seat belt warning chime on your Lexus, then the following steps can help you achieve this and save you a trip to the dealership. Before proceeding, it’s noteworthy to mention that this article is NOT promoting not wearing your seat belt. It is a legal requirement in most states.
How do you reset the seat belt alarm on a Lexus GS300?
Here is the procedure: 1. Set the LCD on the combination meter to the ODO trip. 2. Press and hold the TRIP meter reset knob for ten seconds or more within six seconds of turning the ignition switch to the ON position. Fastening the driver’s seat belt while holding the knob cancels the buzzer reminder.
How do you turn off the ignition on a Lexus RX?
Figure 2. Example of the odometer displaying ODO reading. Press the start button again to turn the ignition off. Then, for the third time, press the start button without pressing the brake pedal to turn the ignition on without turning the car on. This step must be done within 6 seconds after turning the power switch ON.
How do you reset the seat belt alarm?
Press and hold the TRIP meter reset knob for ten seconds or more within six seconds of turning the ignition switch to the ON position. Fastening the driver’s seat belt while holding the knob cancels the buzzer reminder. (You may have to hit the reset meter knob to cycle through b-ON to b-OFF)
Can you turn off the no seat belt alarm on a Lexus IS?
Permanently turn off the “no seat belt” alarm in your Lexus IS with these simple steps. This article applies to the Lexus IS 250, IS 350 (2005-2014). There are only two ways to silence the seat belt alarm in a Lexus. Buckling up the seat belt will do it, but you can avoid this annoyance all together. Position yourself in the driver’s seat.
How do I Turn Off the seat belt alarm?
In order to avoid the confusion of another alarm, be certain that your seat belt is off, your foot is of the brake, and your doors are closed. Then, turn on the car. Make sure the counter in your dash board is set to the lifetime odometer mode. Press it until it reads “ODO” with the total number of miles displayed. Then, turn the ignition off.
Figure 2. Example of the odometer displaying ODO reading. Press the start button again to turn the ignition off. Then, for the third time, press the start button without pressing the brake pedal to turn the ignition on without turning the car on. This step must be done within 6 seconds after turning the power switch ON.