How do you align the tires on a Lexus?
Take your contractor’s string, cut to the length of the car and loop each end on each jack stand. Pull your jacks apart until the string is taught. Now raise each jack stand to the center hub of your wheels. Make sure your string is one inch from the center of each wheel, at the front and rear. Figure 1. Attach string to jack stands.
What’s the best way to alignment a car?
It’s also important to note that alignment MUST be done on a known level surface. Place two jack stands at each bumper of your vehicle. Take your contractor’s string, cut to the length of the car and loop each end on each jack stand. Pull your jacks apart until the string is taught.
What does toe out mean on a Lexus?
If the tire is touching at the front of the wheel, you have “toe-out”. Toe is the angle of your wheel when looking down at the tire. If the rear of the tire is touching the string, you have “toe-in.” Your tires should be 2mm toe in per lexus specs. First make sure your steering wheel is straight.
Take your contractor’s string, cut to the length of the car and loop each end on each jack stand. Pull your jacks apart until the string is taught. Now raise each jack stand to the center hub of your wheels. Make sure your string is one inch from the center of each wheel, at the front and rear. Figure 1. Attach string to jack stands.
If the tire is touching at the front of the wheel, you have “toe-out”. Toe is the angle of your wheel when looking down at the tire. If the rear of the tire is touching the string, you have “toe-in.” Your tires should be 2mm toe in per lexus specs. First make sure your steering wheel is straight.
Where are the tie rods on a Lexus?
A tie rod ties your Lexus’ steering rack to the steering arm. Tie rods are subject to a lot of abuse, especially if you travel rough roads or hit a lot of curbs. On a Lexus vehicle, there are inner and outer tie rods.
It’s also important to note that alignment MUST be done on a known level surface. Place two jack stands at each bumper of your vehicle. Take your contractor’s string, cut to the length of the car and loop each end on each jack stand. Pull your jacks apart until the string is taught.