Does a starter need a relay?
It doesn’t need a starter relay but you can use one if you want. You can also eliminate the starter button. Without the relay, your starter power comes from the start position on the ignition switch which is on a spring like a car.
What should I do if I have a bad starter relay?
They can also be hazardous and can cause damage. If you run into symptoms of a bad starter relay or solenoid with your car, truck, or SUV, make sure to have a trusted technician to diagnose the specific problem. This article is intended only as a general guidance document and relying on its material is at your sole risk.
How is the ignition switch connected to the starter relay?
The opposite side would be connected to the starter solenoid. I connected the jumpers to the relay. Then Tucked it up out of the way. I think I need some velcro or something here to keep it in place. The Hot wire from the battery went through the firewall where the hood latch cable feeds through. I added a fuse block just in case.
How to bypass ignition switch for starter solenoid?
This is what I did to bypass the ignition switch for the starter solenoid, and just run the relay coil from the ignition switch. I made 3 12″ long jumpers. Then I had to check to see which side of the relay the Ignition switch was on. The opposite side would be connected to the starter solenoid. I connected the jumpers to the relay.
What to do if your starter wont turn on?
If you don’t have power you will need to gain access to the neutral safety switch (A/T only) and test input and output power. If you have power in, but not out. Confirm the car is in park/neutral before replacing the switch. The power input pin in the ignition switch draws power directly from the battery with no fuse or fusible link seemingly.
They can also be hazardous and can cause damage. If you run into symptoms of a bad starter relay or solenoid with your car, truck, or SUV, make sure to have a trusted technician to diagnose the specific problem. This article is intended only as a general guidance document and relying on its material is at your sole risk.
The opposite side would be connected to the starter solenoid. I connected the jumpers to the relay. Then Tucked it up out of the way. I think I need some velcro or something here to keep it in place. The Hot wire from the battery went through the firewall where the hood latch cable feeds through. I added a fuse block just in case.
This is what I did to bypass the ignition switch for the starter solenoid, and just run the relay coil from the ignition switch. I made 3 12″ long jumpers. Then I had to check to see which side of the relay the Ignition switch was on. The opposite side would be connected to the starter solenoid. I connected the jumpers to the relay.
What kind of wire do you use for a starter relay?
Use 16 gauge wire and quality insulated crimped terminals if performing this wiring for the first time. Sometimes the starter relay negative is routed through a neutral safety switch and then to ground, particularly on vehicles with automatic transmissions.