Why is passenger side heat control not working?

Why is passenger side heat control not working?

An expert who has achieved level 1. An expert that has 1 follower. These are all good advice as I would start with a vacuum issue that is not switching the passenger side to cool or the other being the blend actuator is history and not shutting down the heat side and open the A/C side of things.

What’s the air temp on the left side of the car?

Repeated testing shows no leaks/full recovery. Since getting the car back the drivers side air temp is always 15 F or more degrees warmer! the driver’s vent is always 68F or higher; while the passenger side air vent can drop to 51F. Been this way now for almost two weeks.

How do you calibrate an automatic temp control system?

This is required to calibrate ATC (automatic temp control) systems. 1. Turn the ignition on. 2. Turn the blower control to off. 3. Press the EBL mode switch down for five seconds and then release it. Wait approximately 90 seconds for the calibration process to run to completion before proceeding.

Why is the left side of my car not getting hot?

When I got the car back it still wasn’t getting as hot as I thought it should and that’s when I noticed the difference in the temperature coming from the vents.

An expert who has achieved level 1. An expert that has 1 follower. These are all good advice as I would start with a vacuum issue that is not switching the passenger side to cool or the other being the blend actuator is history and not shutting down the heat side and open the A/C side of things.

Why are the heated seats on my Silverado not working?

Hi I have a 2003 Silverado with the heated seats and while testing them out before it gets cold outside I have noticed that I am having trouble with them turning off by themself. Seems to be a problem with the drivers side mostly, but when the drivers side has a problem it shuts both sides off.

Why are the heated seats not working on my Dodge Charger?

The heated seats can shut OFF early or may not turn on when the seat is already warm. The issue with the seats were related to the wiring. The fix was removing all of the wires and re-plugging them. They work now. It was a quick fix. Just an update: When the outside temp is 10 degrees or lower my driver side seat works every time.

What to do if heated seats won’t stay on?

A fault in heated seats, adjustable pedal or seat recliner will affect BOTH heated seats. Note:: Even if the vehicle is not equipped with adjustable pedals DTC B3606 still may set. Recommendation/Instructions: To help isolate the area of concern use the Tech 2 and go to “Sensor Data” in the Drivers Seat Module.

Why is my driver side heat not working?

The driver side heat on my 2014 Ford Edge was not working. I did two things that could have fixed it. The first was to hold the defrost and control / power button down for a few seconds, the press the power button. I also put it into auto mode and let it cycle, then switched it back to front air. One of those two things worked. Loading…

Why does my seat heater not turn on?

Some customers may comment that occasionally the seat heater will not operate when activated. If the ignition key is cycled OFF and back ON again, the heated seat will operate correctly. Also, on some LB7 diesel engine vehicles, the seat heater may turn itself off during the first 10 minutes of operation.

Why does my GMC heated seat keep shutting off?

2004 GMC: heated seats The driver’s side heat keeps shutting off 2004 GMC: heated seats The driver’s side heat keeps shutting off Hello and welcome to Just answer.com, Super mechanic here. About your vehicle. There has been a service bulletin for that type of concern. It involves a reprogramming of the driver seat module.

Why does the passenger side blow the most heat?

Now the dials all seem to work appropriately, but again the passenger and rear vents blow high heat no matter what the setting. As a result, we either have to turn all the air off or switch every vent off except the driver side when we want AC. What could be causing this?

Posted In Q&A