Where is the crankshaft position sensor located on a 2011 Buick Regal?
The 2011 Buick Regal 2.2 L crankshaft position sensor is mounted to the side of the engine block, above the starter and next to the transmission. It is accessed under hood in the engine bay and generally secured witH1/4 inch bolts.
Where is the crankshaft position sensor located on a car?
The location of the crankshaft position sensor can vary from one vehicle to another. Obviously it must be close to the crankshaft, so it is most often located on the front underside of the engine. It can usually be found mounted to the timing cover. Sometimes it may be mounted at the rear or the side of the engine.
What is the diagnostic code for a bad crankshaft sensor?
There are many diagnostic codes for various problems and they can be checked using a diagnostic scan tool. If the code lies between P0335 and P0338 it indicates that the problem is with the crankshaft sensor. This is one of the simplest ways to diagnose a problem with the crankshaft position sensor.
What happens if your crankshaft sensor is out of sync?
If your defective crankshaft position sensor is extremely out of sync, you might have trouble getting your vehicle started. Furthermore, you might have difficulty keeping it started. This is usually only a problem when the problem has persisted for some time, and you likely have various other underlying issues too.
How much does it cost to replace a crankshaft sensor?
The average cost to replace a crankshaft sensor ranges between $150 and $250. However, it’s not uncommon for those prices to skyrocket if you have a higher-end vehicle. That’s because the labor costs are typically between $90 and $110. From there, the rest of the cost comes down to parts.
The location of the crankshaft position sensor can vary from one vehicle to another. Obviously it must be close to the crankshaft, so it is most often located on the front underside of the engine. It can usually be found mounted to the timing cover. Sometimes it may be mounted at the rear or the side of the engine.
How can I tell if my crankshaft sensor is bad?
Another sign of a crankshaft position sensor problem is rough idling. While idling at a red light or otherwise stopped, you may notice the engine grinding or vibrating. When this happens, it means the sensor is not monitoring the crankshaft’s position, leading to vibrations that affect overall engine power.
The sensor itself will cost between $8.00 and $49.00 (US) on Amazon. Labor will run between $60.00 and $180.00 depending on the location of the sensor. Start by locating the sensor which can be done by inspecting the engine at looking for any sensor at the lower level that matches the new sensor you have just purchased.
What to do if crankshaft angle sensor is oily?
If the crankshaft angle sensor is oily now is a good time to use a small amount of carburetor cleaner to remove the oil to get a clean start on the job. An electrical connector will be held to the sensor using a plastic clip which you much push down or pull outward to release.