How do you remove camshaft from Toyota Camry?
Uniformly loosen and remove the No. 2 camshaft’s 10 bearing cap bolts in the sequence shown in the illustration. Then remove the 5 bearing caps. Raise the No. 2 camahaft and remove it. Then remove the sprocket bolt. Remove the timing chain sprocket and the timing chain from the No. 2 camshaft.
How much torque does a Toyota Camry have?
Torque: 30 N·m (301 kgf·cm, 22 ft·lbf) for bearing cap No. 1 9.0 N·m (92 kgf·cm, 80 in.·lbf) for bearing cap No. 3 16. INSTALL No.2 CAMSHAFT a. Put the camshaft on the cylinder head with the painted mark of the link of chain aligned with the timing mark of the camshaft timing sprocket. b. Raising the camshaft, temporarily tighten the sprocket bolt.
Where is timing mark 0 on Toyota Camry?
SET No. 1 CYLINDER TO TDC/COMPRESSION Turn the crankshaft pulley, and align its groove with the timing mark 0 of the timing chain cover. Check that the timing marks of the camshaft timing gear and camshaft timing sprocket are aligned with the timing marks of the bearing cap as shown in the illustration.
What should timing gear be on Toyota Camry?
NOTICE: Be sure not to turn the camshaft timing gear to the retarded angle side (to the right direction). Check that there is no clearance between the gear’s fringe and the camshaft. Tighten the fringe bolt with the camshaft timing gear fixed.
Where are the tensioner bolts on a Toyota Camry?
Two bolts are used to adjust the tension on the belt. They are at 90 degrees in relation to one another. They both need to be loosened, but do not need to be removed. The tensioner bolt on the left hand side is difficult to get to.
How do you remove a pulley from a Toyota Camry?
If you are extremely lucky, the pulley will come off by hand once you remove the two smaller bolts that hold it in place. This is likely not going to be that easy. You will want to use a pulley removal kit that can be had pretty cheaply. Make sure you use one like in the figure below.
How to install timing chain on Toyota Camry?
Install the timing chain on the camshaft timing gear, with the painted mark of the link aligned with the timing marks of the camshaft timing sprocket. b. Examine the front marks and unmbers of the 5 bearing caps and install them. Then install the 10 bearing cap bolts.