How do you set an Autometer tach?
Push and hold red button. Pointer will display the tachometer’s shift- point and the Shift Lite will activate. 2. To set your desired shift-point, continue depressing the red button, then push and turn the Shift-Set knob until the pointer reaches the desired RPM.
How to install an Auto Meter tach adapter on your Mustang?
After you cut all 8 coil powers, use a 16g wire and link all the power (harness side) cut halves together, then hook to the solid red of the 9117 tachometer adapter. Next, use 16g wire and link all the coil-side cut halves together and hook to the red wire with a green stripe of the 9117 tachometer adapter. Ground the black 9117 adapter wire.
How do you hook up a tachometer to an ignition?
Attach the ground wire for the tachometer to a suitable ground plane on your vehicle. Hook the ignition/ACC wire and lighting wire to available posts on the fuse block of your vehicle.
Where are the pin numbers on a Mustang tach?
Pop the plastic cover off the top of this connector to expose where the wires enter the connector and to expose the wire pin numbers. Locate pin number 34 which will be in the corner of this connector. Depending on the specific year and trim of Mustang, the wire color can be Red, Red with a Green stripe, or a White wire with a Blue stripe.
Where is the gray tach output wire on a Mustang?
GRAY – Tach output signal wire. Connects to the green Tach trigger wire or other RPM operated component. Connecting to Coil Per Cylinder (Other Ford cars & Trucks may be the same as below, but with different 42 pin connector location)
After you cut all 8 coil powers, use a 16g wire and link all the power (harness side) cut halves together, then hook to the solid red of the 9117 tachometer adapter. Next, use 16g wire and link all the coil-side cut halves together and hook to the red wire with a green stripe of the 9117 tachometer adapter. Ground the black 9117 adapter wire.
How do you hook up a tachometer to a MSD Ignition?
Cut the wire from the spool, and strip the end of it with wire strippers. Attach a male connector to the end of the tach trigger wire. Slide the male connector to the port on the side of the MSD ignition control box.
How do you hook up a tachometer to a car?
Slide the male connector to the port on the side of the MSD ignition control box. Attach the ground wire for the tachometer to a suitable ground plane on your vehicle. Hook the ignition/ACC wire and lighting wire to available posts on the fuse block of your vehicle.
GRAY – Tach output signal wire. Connects to the green Tach trigger wire or other RPM operated component. Connecting to Coil Per Cylinder (Other Ford cars & Trucks may be the same as below, but with different 42 pin connector location)