What do the trouble codes on a Suzuki mean?
Suzuki Check Engine Light Codes Trouble Codes› Suzuki Trouble Codes Full list of OBD II Diagnostic Trouble Codes for your Suzuki. If your Check engine light is on you may have a serious problem. Scan your codes and follow the chart to determine what the code means. Some shops will scan your codes for free.
Where to find the DTC code on a Suzuki?
See chapter 5 of the factory service manual (FSM) for more information. –DTCs may be accessed by installing a jumper wire between diagnostic check connector terminals B and C, located in the RH rear of the engine compartment, then turning the ignition ON.
Where is the diagnostic terminal on a Suzuki?
The diagnostic terminal is the lower right fuse slot. NOTE: This information does not apply to carbureted engines, as they have a “check engine” light but don’t store codes. You have to troubleshoot manually to determine which sensor is causing the problem. See chapter 5 of the factory service manual (FSM) for more information.
What is the diagnostic code for a Suzuki Sidekick?
Suzuki: Diagnostic Trouble Codes. 86–95 Samurai, Swift & 89 Sidekick. NOTE: This information does not apply to carberated engines, as they will not have a check engine light and no codes are retrievable.
What are the problems with the Suzuki XL-7?
My wife has an 02 XL-7 and on start up it make a rubbing plastic sound for about 2-3 seconds and goes away I can’t pin point where it is coming from and it also has the problem with the 4wd that once you turn it on it won’t come out until you stop and put it into reverse.
When to get Suzuki XL-7 under warranty?
If you purchased your truck after August 2002 and have less than 100K miles, you should be able to get it worked on under warranty. If you purchase it before August 2002 and have more than 3years and/or 36K miles on it, you will have to cover the repairs yourself.
Where is the DTC code on a Suzuki?
NOTE: This information does not apply to carberated engines, as they will not have a check engine light and no codes are retrievable. DTCs may be accessed by installing a spare fuse into the fuse box diagnostic terminal, located under the LH side of the instrument panel, then turning the ignition On.
Where to find check engine light codes on Suzuki?
These are listed in numerical order for easy searching. When retrieving Suzuki check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
Suzuki Check Engine Light Codes Trouble Codes› Suzuki Trouble Codes Full list of OBD II Diagnostic Trouble Codes for your Suzuki. If your Check engine light is on you may have a serious problem. Scan your codes and follow the chart to determine what the code means. Some shops will scan your codes for free.
What does the Suzuki Fi flashing light code mean?
It means there could be a possible serious abnormality of the sensor signals and the ECM has determine it is unsafe to run the engine until you get it checked. When this happens the instrument cluster reads “FI” continuously and the FI led will flash.
What does Fi mean on Suzuki GSXR 2006?
After riding over 10,000 miles on my 2006 750, FI started to show instead of temperature… (only) sometimes. Took it to dealer who said it needed to adjust exhaust valve (the wires) – as the error was shown because the valve did not fully close. 8,000 more miles since then and no problem. ..
What happens when a diagnostic code is thrown on a Suzuki Volusia?
The fi lite will stay on until the code is downloaded (paper clip or factory switch). The fi lite will illuminate again if the anomaly that caused the code is not fixed, (it will just throw the same code again).