Where do you hook up a fog light?
Connect the final set of wires into the passenger compartment to go to the fog light switch. The appropriate wires and their connections will be identified by the supplied kit’s schematic. Locate a suitable mounting location for the fog light switch, and mount it securely.
How to wire fog and driving lights harness?
Turn off the ignition and the headlamps. Disconnect the battery. For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead. Turn off the ignition and the headlamps. Disconnect the battery.
How does a toggle switch work on a fog light?
Installing a toggle switch into your fog lights’ electrical circuit allows you to control them remotely. Flipping the switch to the “on” position completes the electrical circuit and allows power to flow from the battery to the lights, while flipping the switch to the “off” position breaks…
Where is the relay wire for a fog light?
Connect one BLACK lead to the vehicle ground and to the relay terminal labeled 86. Connect the YELLOW wire to the yellow switch wire terminal and to the relay terminal labeled 85. Test the operation of the lamps as follows: Re-connect the battery.
How do you hook up a fog light?
Throw down the wiring harness form the relay and switch kit and connect it to your fog lamp unit. Step 3: Lock your fog light’s tabs on the right to your bumper. You may skip this step if your LED fog light comes standard with its own bezel. Step 4: Pop in the bezel back in place.
Where does the green wire go for a fog light?
Green wire connects directly to the battery to power switch / relay. Loosen the stud or bolts securing the fog or driving lamp to the bracket to adjust the lights up or down. Loosen the mounting bolts to the vehicle to adjust the lights left and right. Position the vehicle on a flat surface at a distance of 25 feet (7.6 m) from a wall.
Where to Mount Universal fog lights on car?
If you are using a universal fog light kit, the only changes are that you can skip step 10, and you get to choose where to mount your fog lights. See the guide in the link above for suggestions on mounting universal fog lights. Disconnect the negative battery terminal. Lay the wiring harness in the engine bay, approximating the layout you want.
Turn off the ignition and the headlamps. Disconnect the battery. For Driving Lights: Turn on the high beam headlamps. Connect the end of the circuit tester to ground (-) and use the tester to locate the headlamp high beam lead. Turn off the ignition and the headlamps. Disconnect the battery.